The illustrated glossary
Inside your appliance. Parts, in plain English.
Learn what a part does before you ring, so you and the technician begin from the same point.

Find a term, A–Z.
Igniter, cap, port. Small parts, big flame.
Range words, explained
What sits under the grate.
- Igniters and sealed burners
- A Viking gas range lights each burner with an igniter that clicks and sparks as the knob turns. The 3 Series and 7 Series troubleshooting tables list a tripped circuit or blown fuse for igniters that do nothing, a closed gas valve or interrupted supply for sparks without flame, and wet or dirty igniters for constant clicking.
- Condenser coil and the CL reminder
- The condenser is the finned coil behind the kick plate that sheds heat from a Viking 7 Series integrated refrigerator. Dust and pet hair slow it down, and the temperature display blinks CL as a reminder. The 7 Series guide asks for a cleaning every 6 months by vacuuming the front of the coil.
- Water level sensor and Er15 / Er16
- The FNIU515D nugget ice machine uses a water level sensor to confirm water is arriving and draining. If no level is detected for 2 minutes of water supply, the display shows Er15; if the lower limit is not detected within 2 minutes of draining, it shows Er16. The table lists a water supply pressure check and a sensor check as the action.
Burners, igniters and air.

Igniters and sealed burners
A Viking gas range lights each burner with an igniter that clicks and sparks as the knob turns. The 3 Series and 7 Series troubleshooting tables list a tripped circuit or blown fuse for igniters that do nothing, a closed gas valve or interrupted supply for sparks without flame, and wet or dirty igniters for constant clicking.

Burner ports and air shutters
When a Viking gas burner lights but the flame is large, distorted or yellow, the 3 Series and 7 Series troubleshooting tables list three causes: clogged burner ports, the wrong type of gas, or air shutters that are not adjusted properly. The first is a cleaning job; the other two belong with a technician.

Hot surface igniter on side burners
The 5 Series gas side burners and power burner light with a hot surface ignition system. Viking’s guide says to push and hold the control knob for 5-7 seconds so the igniter can heat up, then turn to LITE. During an installation test, the igniter should glow bright and steady.

Air shutters and yellow flames
A yellow flame on a Viking side burner means a lack of air, according to the 5 Series side burner guide, though orange tips are normal with dusty air or heavy grease. The fix is to rotate the air shutters, but only after the accessory has cooled completely and all controls are off.

Backlit knobs and the red error light
The knobs on a Viking 7 Series range and rangetop have lit rings and a backlit bezel. The color has a meaning: blue or white in normal use, yellow during self-clean, and red for an error. In red, the rings flash a count for the error code, though the guide prints no table that decodes it.
Oven door and probe.

Oven door latch and self-clean lock
A Viking self-cleaning oven locks its door with a latch for the cycle. On the 7 Series the guide says the door releases once the oven is at a safe temperature, and if a cycle is canceled in the first 30 seconds the door may stay locked until you turn both knobs to SELF-CLEAN and then OFF. Touch-control wall ovens print LATCH ERROR.

Meat probe and PROBE ERROR
On a Viking touch-control wall oven, the meat probe plugs into a jack in the oven. PROBE ERROR means the probe is open or shorted. The F20813 manual’s first step is simple: the probe may not be plugged in, so plug it in, press OFF to clear the message, and call for service only if the error persists.
Cold, ice and water.

Condenser coil and the CL reminder
The condenser is the finned coil behind the kick plate that sheds heat from a Viking 7 Series integrated refrigerator. Dust and pet hair slow it down, and the temperature display blinks CL as a reminder. The 7 Series guide asks for a cleaning every 6 months by vacuuming the front of the coil.

Door gaskets
The gaskets are the soft seals around the doors of a Viking refrigerator or freezer. The 5 Series and 7 Series guides say to clean them every three months, the way you clean the interior, and to apply a light film of petroleum jelly so they stay pliable. A dirty or stiff gasket can leave the door slightly open.

Water filter and the FILTER reminder
A Viking 7 Series integrated refrigerator holds its water filter in the bottom right corner behind the door. The FILTER button lights when it is time to change it. You push in and turn the cartridge a quarter turn to remove it, fit the cap on the new one, then press the button to reset.

Air-cooled condenser and Time to Clean
Viking 5 Series clear and nugget ice machines are cooled by a condenser the guides compare to a car radiator: fins and tubes that clog with dirt and lint. The Time to Clean light comes on after 6 months of use. For low capacity, the troubleshooting guide says to clean the air-cooled condenser fins.

Water level sensor and Er15 / Er16
The FNIU515D nugget ice machine uses a water level sensor to confirm water is arriving and draining. If no level is detected for 2 minutes of water supply, the display shows Er15; if the lower limit is not detected within 2 minutes of draining, it shows Er16. The table lists a water supply pressure check and a sensor check as the action.

Drain pump and drain lamp
A Viking 5 Series nugget ice machine (FNIU515D) removes melt water with a drain pump that has its own reservoir. The pump turns on by itself as the reservoir fills, even in Sabbath mode. The Drain lamp lights when the drain valve opens, and Er16 means the water level sensor was not reached within 2 minutes of draining.

Temperature zones
A Viking dual-zone wine cellar has an upper and a lower zone, each set between 38 and 65 degrees F in the FWUI5242G guide. The lower zone cannot be set colder than the upper, and it cannot be more than 20 degrees above it. Changing the upper zone can move the lower one on its own.
Hoods, microwaves and cooktops.

Baffle filters
Viking professional wall hoods use stainless steel baffle filters, which trap grease in U-shaped channels. The 18-inch hood guide says to examine them periodically and wash them in a dishwasher or a sink with hot soapy water. Do not use caustic detergent, and do not take the filters apart.

Charcoal filters and mesh filters
A Viking recirculating chimney hood has a charcoal filter that the guide says to replace every 6 months to 1 year, depending on the amount and type of cooking. Do not put charcoal filters in the dishwasher. The mesh filters beside them can be washed, and after cleaning a button hold clears the reminder display.

Grease filter indicator (green LED)
The RVL Pureline Pro ceiling hood counts cooking hours. After 20 hours of cooking, a green LED on the hood tells you the grease filter needs cleaning. The guide says never to run the hood without the grease filters, because heavy contamination creates a fire risk.

Door seals and safety latches
A Viking microwave has door seals and safety door latches that must be intact. The guides rule out operating the oven when the door is bent, a hinge or latch is broken or loosened, or the seals and sealing surfaces are damaged. Only properly qualified service personnel should repair or adjust it.

Turntable and turntable support
A Viking countertop or built-in microwave turns food on a removable turntable that sits on a support over a motor shaft. The guides say never to run the oven without the turntable and its support, and that it turns in either direction. The motor shaft is not sealed, so wipe up spills right away.

Waveguide cover
The waveguide cover in a Viking RVM320SS microwave sits on the right wall of the oven cavity. It is made from mica, so it needs special care. Wipe food spatter off it with a damp cloth right away, because built-up splashes may overheat and cause smoke or possibly catch fire. Never remove it.

Touch controls and the F-code display
Viking Designer electric cooktops run on touch controls. A control panel that finds an electronics problem stops all heating elements and shows F plus a second letter on the timer display. The F20699 table lists 14 of them, from key and keyboard errors to temperature sensor and relay errors. On the 6 Series induction cooktops you must hold a touch for a few seconds.

Key lock and child lock (L)
A Viking 6 Series cooktop has a Key Lock button that freezes the settings while the elements keep running, and a Child Lock that shows L on the timer and above each control. Unlock it by pressing Key Lock and Pause together. The lock returns after power is switched off and on unless you disable it.
Dishwasher water path.

Filters and the coarse strainer
A Viking 451 or 324 Series dishwasher keeps a coarse strainer, a fine filter and a primary filter in its base, under the lower rack. Viking says never to run the machine without the filters in place. You lift out and empty the strainer, can twist out the fine filter, and should leave the primary filter alone.

Drain hose and high loop
The drain hose carries wash water out of a Viking built-in dishwasher toward the plumbing under your sink. The 451 Series chart lists a clogged or kinked hose when the machine will not drain, and asks for a cone fitting cut to an inner diameter of at least 3/4 inch. The 324 Series chart adds a high loop.
Which part, which problem, which code.
Pick a part to see which trouble it can bring on and which messages name it.
Beverage-center
Freezer
Grill
Hood
Ice-maker
Microwave
Range
Refrigerator
Wine-cooler
Dishwasher
Oven
Cooktop
What is in the glossary?
Short definitions of parts named in Viking manuals, from igniters and burner air shutters to condenser coils. Every entry describes the part's purpose.
If a part is listed, is mine faulty?
Not at all. Entries define words and say nothing about your own appliance. They help you follow code pages and technician comments.
Is an entry enough to go shopping for parts?
No. Parts that resemble each other vary across series, and a match needs confirming at the appliance before any purchase.
Where do links in an entry lead?
To pages showing the part in a concrete setting, like a code or a symptom, so its place in the appliance becomes clear.
Viking codes, symptoms, parts, visits
From the message to your next move.
Viking range burner will not light
A Viking range burner that will not light usually comes down to power, the gas valve, or a dirty igniter. Viking's printed table separates the causes by what you see: no spark, spark but no flame, endless sparking, or a yellow flame. With a gas smell, leave the knobs alone and phone your gas supplier.
Range repair
Book a diagnostic for your series at the appliance itself.
Find your metro
Office particulars and the entry details to give us.









