What it means
Fc, with a lowercase c, is the over-temperature code on a Viking Designer cooktop. The control checks its own ambient temperature and stops all activity when inner parts overheat. Let the appliance cool down.
Viking cooktop Fc / Control code
Fc, with a lowercase c, is the over-temperature code on a Viking Designer cooktop. The control checks its own ambient temperature and stops all activity when inner parts overheat. Let the appliance cool down.
Also shown as Fc
Fc, with a lowercase c, is the over-temperature code on a Viking Designer cooktop. The control checks its own ambient temperature and stops all activity when inner parts overheat. Let the appliance cool down.
They have already stopped; make sure no pan is left heating.
Fc returns after the cooktop has cooled.
Your Viking checklist, kept on this device only

They have already stopped; make sure no pan is left heating.

The manual says to let the appliance cool down.

Make sure nothing blocks airflow around the cooktop.

If Fc comes back after a full cooldown, book a visit.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visitA simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.

Component reference
Viking Designer electric cooktops run on touch controls.
Read the definitionThe control's inner parts. The manual says the panel checks its own ambient temperature.
Read the supporting manualNo. FC, with a capital C, is a key error. Case decides the meaning.
Read the supporting manualThe cooktop can work continuously for a maximum of 10 hours.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20699 EN (091509J) / PDF p.16
Source: the Viking Designer built-in electric cooktop use and care manual, Error Codes table on p. 16.
The manual gives no time, so wait until the cooktop feels cool. If Fc comes back after a full cooldown, book a visit.
No. The control stops all activity until it cools, so nothing will heat meanwhile. Make sure no pan is left on an element and let the cooktop cool down.
No, it is a protective stop. The control checks its own ambient temperature and stops all activity when inner parts overheat, as the manual describes.
Book a visit if Fc comes back after the cooktop has fully cooled. Check first that nothing blocks airflow around it.
Viking codes, symptoms, parts, visits
FC, with a capital C, is a key error on a Viking Designer cooktop, listed in the same row as FA. All heating elements stop and FC shows on the timer display. The manual lists no reset.
Viking’s guides split a dark burner by what the igniter does. Silence means the igniter has no electricity. Clicking without a flame means gas is not arriving. Work out which one you have, try the matching steps below, and call a technician when the burner never catches.
Viking Designer electric cooktops run on touch controls. A control panel that finds an electronics problem stops all heating elements and shows F plus a second letter on the timer display. The F20699 table lists 14 of them, from key and keyboard errors to temperature sensor and relay errors. On the 6 Series induction cooktops you must hold a touch for a few seconds.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.