What it means
FE on a Viking Designer cooktop is a temperature sensor failure, listed with Ft. The control checks its working temperature through a sensor, stops all elements when the sensor fails, and shows FE on the timer display.
Viking cooktop FE / Control code
FE on a Viking Designer cooktop is a temperature sensor failure, listed with Ft. The control checks its working temperature through a sensor, stops all elements when the sensor fails, and shows FE on the timer display.
Also shown as FE
FE on a Viking Designer cooktop is a temperature sensor failure, listed with Ft. The control checks its working temperature through a sensor, stops all elements when the sensor fails, and shows FE on the timer display.
Capital F and capital E.
FE appears on the timer display.
Your Viking checklist, kept on this device only

Capital F and capital E.

Lowercase c is overheating; FE is the sensor itself.

Elements are stopped.

A failed sensor needs a technician.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visitA simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.

Component reference
Viking Designer electric cooktops run on touch controls.
Read the definitionA temperature sensor failure. The error system checks the working temperature of the control, and FE is one of two letters the table lists for a sensor that has failed.
Read the supporting manualFc says inner parts overheated: the control checks its own ambient temperature and stops all activity if inner parts get too hot, and the manual says to let the appliance cool. FE says the sensor reading failed.
Read the supporting manualThe manual lists them together as one failure.
Read the supporting manualThe manual says the cooktop can work continuously for a maximum of 10 hours. It does not tie that limit to FE.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20699 EN (091509J) / PDF pp.12–16
Source: the Viking Designer built-in electric cooktop use and care manual, Error Codes table on p. 16.
Not necessarily. Fc is the over temperature code. FE is about the sensor.
The manual says to let the appliance cool for the overheating stop. The sensor failure row lists nothing.
All of them. The control stops every heating element when it declares an error.
The manual says up to 10 hours of continuous use.
Viking codes, symptoms, parts, visits
Ft on a Viking Designer cooktop is a temperature sensor failure, printed in the same row as FE. All heating elements stop and Ft shows on the timer display. The manual lists no reset.
Viking’s guides split a dark burner by what the igniter does. Silence means the igniter has no electricity. Clicking without a flame means gas is not arriving. Work out which one you have, try the matching steps below, and call a technician when the burner never catches.
Viking Designer electric cooktops run on touch controls. A control panel that finds an electronics problem stops all heating elements and shows F plus a second letter on the timer display. The F20699 table lists 14 of them, from key and keyboard errors to temperature sensor and relay errors. On the 6 Series induction cooktops you must hold a touch for a few seconds.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.