What it means
Ft on a Viking Designer cooktop is a temperature sensor failure, printed in the same row as FE. All heating elements stop and Ft shows on the timer display. The manual lists no reset.
Viking cooktop Ft / Control code
Ft on a Viking Designer cooktop is a temperature sensor failure, printed in the same row as FE. All heating elements stop and Ft shows on the timer display. The manual lists no reset.
Also shown as Ft
Ft on a Viking Designer cooktop is a temperature sensor failure, printed in the same row as FE. All heating elements stop and Ft shows on the timer display. The manual lists no reset.
Capital F and lowercase t.
Ft appears on the timer display.
Your Viking checklist, kept on this device only

Capital F and lowercase t.

Fc, lowercase c, is overheating.

The elements are stopped.

A sensor failure needs a technician.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visitA simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.

Component reference
Viking Designer electric cooktops run on touch controls.
Read the definitionA temperature sensor failure, printed in the same row as FE.
Read the supporting manualFc is the over temperature code. Ft concerns the sensor reading.
Read the supporting manualThe t is lowercase. Viking separates codes by letter case, as with Fc and FC.
Read the supporting manualIt checks its own ambient temperature and stops any activity if inner parts overheat, and the manual says to let the appliance cool. That belongs to Fc.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20699 EN (091509J) / PDF pp.12–16
Source: the Viking Designer built-in electric cooktop use and care manual, Error Codes table on p. 16.
No. Ft is a temperature sensor failure, not the over temperature code. Fc, with a lowercase c, is the one for overheating, so check the letters.
After more than 5 minutes at full power it takes about half an hour for the HOT SURFACE light to fade. At level 1 it is about 10 minutes.
Yes, write the letters exactly. Viking separates codes by letter case, as with Fc and FC, so give the exact spelling of Ft when you book.
No. The manual lists no reset for Ft, a temperature sensor failure. All heating elements stop, so leave the cooktop idle and book a visit.
Viking codes, symptoms, parts, visits
FE on a Viking Designer cooktop is a temperature sensor failure, listed with Ft. The control checks its working temperature through a sensor, stops all elements when the sensor fails, and shows FE on the timer display.
Viking’s guides split a dark burner by what the igniter does. Silence means the igniter has no electricity. Clicking without a flame means gas is not arriving. Work out which one you have, try the matching steps below, and call a technician when the burner never catches.
Viking Designer electric cooktops run on touch controls. A control panel that finds an electronics problem stops all heating elements and shows F plus a second letter on the timer display. The F20699 table lists 14 of them, from key and keyboard errors to temperature sensor and relay errors. On the 6 Series induction cooktops you must hold a touch for a few seconds.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.