What it means
A flashing blue Check Water light on a Viking 5 Series 15 in ice machine means check the water supply. The control checks for water every 20 minutes and restarts ice making by itself once water returns.
Viking ice maker Check Water / Water supply
A flashing blue Check Water light on a Viking 5 Series 15 in ice machine means check the water supply. The control checks for water every 20 minutes and restarts ice making by itself once water returns.
Also shown as Check Water
A flashing blue Check Water light on a Viking 5 Series 15 in ice machine means check the water supply. The control checks for water every 20 minutes and restarts ice making by itself once water returns.
Make sure the water line valve is open.
Check Water keeps flashing with the supply on.
Your Viking checklist, kept on this device only

Make sure the water line valve is open.

Straighten any kink behind the unit.

The control checks every 20 minutes.

If it keeps flashing with the supply on, book a visit.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visit
A simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.

Component reference
Viking undercounter ice machines take water through a valve on the rear panel side, fed by a quarter-inch compression nut.
Read the definitionThe control found no water at its last check. The light flashes blue, the control checks for water every 20 minutes, and ice making restarts by itself when the supply returns.
Read the supporting manualThe panel on the nugget machine lists four lights: ICE MAKING, CHECK WATER, TIME TO CLEAN and CLEAN RESET. The ICE MAKING light glows blue when the machine runs after you press the On/Off switch.
Read the supporting manualThe FNIU515D has no Check Water light; its supply error is Er15. Time to Clean is a separate light that comes on after 6 months of use.
Read the supporting manualYes. The troubleshooting guide's "No ice" row lists the On/Off switch, the electrical breaker and then the Check Water light in that order.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
printed code 070777-000 / PDF p.8
Manufacturer document
Viking Range, LLC (official manual PDF)
form F21311A EN (040116) / PDF p.10
Sources: the Viking 15 in clear ice machine manual (FGIM5151 and FPIM5151, p. 8) and the 5 Series 15 in nugget ice machine manual, p. 10.
The On/Off switch, the electrical breaker and the water supply, in the order the manual lists them under No ice.
No. When the water supply is restored the machine restarts ice making automatically.
The nugget manual gives air from 50 F to 100 F, and says it works best with water at 50 to 60 F and air at 60 to 80 F.
Yes. Both the clear ice and nugget manuals print the same flashing blue Check Water wording.
Viking codes, symptoms, parts, visits
The Time to Clean light on a Viking 5 Series 15 in ice machine comes on after 6 months of use. Clean the ice making system. It is a reminder, not a breakdown.
On a Viking undercounter ice machine, little or no ice usually traces to the control position, the water supply, a blocked drain, a dirty condenser or scale on the evaporator. Check the switch and the water first, then clean the system. Book a technician if the bin stays empty.
Viking undercounter ice machines take water through a valve on the rear panel side, fed by a quarter-inch compression nut. The valve buzzes as it opens to fill the reservoir. When ice output drops, the manual starts with the supply side: a shut valve, a kinked line, low pressure, or an open breaker.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.