Inside the appliance
Gas pressure regulator. In plain English.
A Viking 5 Series outdoor gas side burner, part of the grill family, must run through a pressure regulator. The manual says never connect a gas line directly to the accessory or an unregulated line to the grill. The regulator and orifices match the gas named on the rating plate, and switching gases needs a conversion kit fitted by a qualified technician.

Where it fits.
Gas pressure regulator in the appliance
On the gas hose or manifold feeding the accessory; the rating plate sits on the heat shield behind the front panel.
The photo shows the kind of component. It cannot tell you which replacement fits your series.
The signs that this system wants attention.
Gas pressure regulator trouble can turn up together with a drop in performance or a code that keeps coming back. Testing is required before anyone decides this component is to blame.

Viking grill side burner won’t light
A Viking 5 Series gas side or power burner lights with a hot surface igniter. Push the knob in and hold it 5 to 7 seconds before turning to LITE, and the igniter should glow bright and steady. If it does not, check the GFI outlet, the burner seating and the wind, then book a technician.

Viking grill side burner yellow flame
According to Viking, a yellow flame on this accessory means a lack of air, although a few orange tips are normal with dusty air or heavy grease. The air shutters are adjusted only on a completely cool unit. A smell of gas while cooking means shut everything off.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any check you can make yourself. Beware of standing water and sharp edges. Never touch a wet plug or live wiring, take off service panels, or go beyond what your series' guide allows.
- 1
Read the rating plate
It shows whether the unit is set for natural gas (NAT) or propane (LP). Only use that gas.
- 2
Do not remove the regulator
The manual says removing or failing to fit the supplied regulator can cause fire and injury and will void the warranty.
- 3
Leak-test after any change
Brush a soap and water mix on every joint with the knobs off and gas on. Growing bubbles mean a leak: turn the gas off.
- 4
Use the right cylinder
LP units connect to a standard 20 lb Type 1 cylinder with overfill protection. Always leak-test after a cylinder change.
Cleaning or replacement?
Leave internal testing to a technician.
Gas odor at any time.
The burner lights inside the burner with a whooshing sound after you have turned it off and relit it.
A joint bubbles during a leak test.
Arrange a diagnosticSources and model boundaries.
The Gas pressure regulator guidance rests on these references. Choose the manual that fits your own series.
- User / Install Guide, 5 Series Gas Side Burner Accessories VQGSB5131 | VQGPB5201
Rely on the guide for your precise series, and read how we research these pages.
Can I connect the gas line directly?
No. The manual says a pressure regulator must be installed on all gas equipment and the one supplied must be used.
How do I know which gas the unit is set for?
Check the rating plate behind the front panel or on the back of the accessory. Do not run any other gas.
Who changes between propane and natural gas?
A qualified technician, using the conversion kit included with the accessory.
What if it lights inside the burner in cold weather?
The manual warns propane in extreme cold may do this. Turn the knob off and relight when you hear a whooshing sound.
Viking codes, symptoms, parts, visits
From the message to your next move.
Viking grill side burner won’t light
A Viking 5 Series gas side or power burner lights with a hot surface igniter. Push the knob in and hold it 5 to 7 seconds before turning to LITE, and the igniter should glow bright and steady. If it does not, check the GFI outlet, the burner seating and the wind, then book a technician.
Grill repair
Book a diagnostic for your series at the appliance itself.
Find your metro
Office particulars and the entry details to give us.

