What it means
3-1 means the POTS/PANS light flashes three times and the NORMAL WASH light flashes once. Viking's chart calls it UI-MC Comm Error, a communication error between the user interface and the motor control, and prints only a reset.
Viking dishwasher 3-1 / Flash pairs
3-1 means the POTS/PANS light flashes three times and the NORMAL WASH light flashes once. Viking's chart calls it UI-MC Comm Error, a communication error between the user interface and the motor control, and prints only a reset.
Also shown as 3-1
3-1 means the POTS/PANS light flashes three times and the NORMAL WASH light flashes once. Viking's chart calls it UI-MC Comm Error, a communication error between the user interface and the motor control, and prints only a reset.
Three, then one.
3-1 flashes again after the reset.
Your Viking checklist, kept on this device only

Three, then one.

Hold START for 4 seconds.

See whether the panel responds.

No owner checks are listed.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visitA simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.

Component reference
Buttons on a Viking built-in dishwasher panel light up only once you select them.
Read the definitionUI-MC Comm Error, with only the reset action. The abbreviations are not spelled out anywhere in either manual.
Read the supporting manual1-3 is Motor Control Comms Error and 3-1 is UI-MC Comm Error. Both are communication rows, so count the flashes to tell them apart: three then one for 3-1.
Read the supporting manualThe manual says the cycle buttons flash when there is an error, the beep cannot be disabled, and Start/Resume blinks if a cycle is interrupted. It ties none of these to 3-1 by name.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20879C EN (022213) / PDF p.19
Manufacturer document
Viking Range, LLC (official manual PDF)
form F21216 EN (060113) / PDF p.18
Sources: the Viking 451 Series (p. 19) and 324 Series (p. 18) built-in dishwasher manuals; both print the same flash chart.
The chart does not say. It prints a label for a communication problem and nothing about the keys.
The chart skips it. The rows go 3-1, 3-3, 3-4, 3-5, so a pair 3-2 is not defined in either manual.
The manual only says to hold START for four seconds to reset. It prints nothing about pressing other keys.
Yes. The 451 and 324 Series charts both print 3-1 as UI-MC Comm Error.
Viking codes, symptoms, parts, visits
3-3 means the POTS/PANS light flashes three times and the NORMAL WASH light flashes three times. Viking's chart calls it Drain Pump Error and prints only a reset.
A Viking dishwasher that leaves dishes dirty or cloudy is, per Viking's chart, mostly a loading, detergent or filter matter. Check the filters and strainer first, then the wash arms, rinse agent and detergent amount. Odor and slow drying have their own entries, covered below.
Buttons on a Viking built-in dishwasher panel light up only once you select them. Pressing START wakes the unit; the wash begins once the door latches inside a 4-second window. A START button that blinks means standby after a mid-cycle door opening; blinking cycle buttons mean look up the flash pair.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.