What it means
3-4 means the POTS/PANS light flashes three times and the NORMAL WASH light flashes four times. Viking's chart calls it Motor Status and prints only a reset.
Viking dishwasher 3-4 / Flash pairs
3-4 means the POTS/PANS light flashes three times and the NORMAL WASH light flashes four times. Viking's chart calls it Motor Status and prints only a reset.
Also shown as 3-4
3-4 means the POTS/PANS light flashes three times and the NORMAL WASH light flashes four times. Viking's chart calls it Motor Status and prints only a reset.
Three, then four.
3-4 flashes again after the reset.
Your Viking checklist, kept on this device only

Three, then four.

Hold START for 4 seconds.

Check for the pair.

No owner checks are listed.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visit
A simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.
Motor Status, with a reset as the only action. It is a short label with no qualifier such as control or voltage.
Read the supporting manual3-5 is Motor Under Voltage, and 1-2 is Motor Control Status Error. 3-4 is the plain Motor Status row between them.
Read the supporting manualThe chart defines no extra signal for motor rows. Only the separate Pan Flood row has its own pattern, both lights flashing continuously per Note A.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20879C EN (022213) / PDF p.19
Manufacturer document
Viking Range, LLC (official manual PDF)
form F21216 EN (060113) / PDF p.18
Sources: the Viking 451 Series (p. 19) and 324 Series (p. 18) built-in dishwasher manuals; both print the same flash chart.
The chart does not say. Treat it as unidentified until a technician checks.
The five-year limited warranty lists a circulation motor/pump and a drain motor/pump in years four and five, subject to its terms.
The chart has a separate Motor Under Voltage row, 3-5. It does not tie 3-4 to the supply.
Error messages beep and the beep cannot be switched off. It stops when the unit is reset.
Viking codes, symptoms, parts, visits
3-1 means the POTS/PANS light flashes three times and the NORMAL WASH light flashes once. Viking's chart calls it UI-MC Comm Error, a communication error between the user interface and the motor control, and prints only a reset.
A Viking dishwasher that leaves dishes dirty or cloudy is, per Viking's chart, mostly a loading, detergent or filter matter. Check the filters and strainer first, then the wash arms, rinse agent and detergent amount. Odor and slow drying have their own entries, covered below.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.