What it means
3-3 means the POTS/PANS light flashes three times and the NORMAL WASH light flashes three times. Viking's chart calls it Drain Pump Error and prints only a reset.
Viking dishwasher 3-3 / Flash pairs
3-3 means the POTS/PANS light flashes three times and the NORMAL WASH light flashes three times. Viking's chart calls it Drain Pump Error and prints only a reset.
Also shown as 3-3
3-3 means the POTS/PANS light flashes three times and the NORMAL WASH light flashes three times. Viking's chart calls it Drain Pump Error and prints only a reset.
Check for standing water.
3-3 flashes again after the reset.
Your Viking checklist, kept on this device only

Check for standing water.

Hold START for 4 seconds.

Watch whether the water leaves.

The chart lists no pump checks.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visit
A simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.
Drain Pump Error, with only a reset as its action. The numbered drain checks belong to 1-5, not to this row.
Read the supporting manual1-5 is Drain Error and it comes with six steps: the sink and disposal, hose clogs and kinks, the disposal plug, the high loop, level, and filters. 3-3 names the pump.
Read the supporting manualThe filter section says large food particles that cannot pass through the drainage pump collect in the coarse strainer, and that a little water in the strainer area is normal.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20879C EN (022213) / PDF p.19
Manufacturer document
Viking Range, LLC (official manual PDF)
form F21216 EN (060113) / PDF p.18
Sources: the Viking 451 Series (p. 19) and 324 Series (p. 18) built-in dishwasher manuals; both print the same flash chart.
They are printed for 1-5 only. Clearing the coarse strainer and checking the hose does no harm, but the chart does not promise it fixes 3-3.
No. The manual says a small amount of water remaining in the coarse strainer area is normal.
Neither manual describes it. The manual's safety list says not to repair or replace parts unless the manual recommends it.
Do not reach into it blindly. Switch the dishwasher off, bail the water out with a cup and book a visit if the code returns.
Viking codes, symptoms, parts, visits
3-1 means the POTS/PANS light flashes three times and the NORMAL WASH light flashes once. Viking's chart calls it UI-MC Comm Error, a communication error between the user interface and the motor control, and prints only a reset.
A Viking dishwasher that leaves dishes dirty or cloudy is, per Viking's chart, mostly a loading, detergent or filter matter. Check the filters and strainer first, then the wash arms, rinse agent and detergent amount. Odor and slow drying have their own entries, covered below.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.