What it means
Shr, or oPn, on a Viking 5 Series built-in freezer is the temperature sensor alarm. The alarm sounds and the display shows oPn or Shr. Press ALARM OFF. If the display does not return to showing the temperature, book a visit.
Viking freezer Shr / Sensor alarm
Shr, or oPn, on a Viking 5 Series built-in freezer is the temperature sensor alarm. The alarm sounds and the display shows oPn or Shr. Press ALARM OFF. If the display does not return to showing the temperature, book a visit.
Also shown as Shr
Shr, or oPn, on a Viking 5 Series built-in freezer is the temperature sensor alarm. The alarm sounds and the display shows oPn or Shr. Press ALARM OFF. If the display does not return to showing the temperature, book a visit.
This silences the alarm.
The display still shows oPn or Shr after Alarm Off.
Your Viking checklist, kept on this device only

This silences the alarm.

It should return to showing the temperature.

Shr or oPn.
If the display does not return, Viking says to contact a technician immediately.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visitA simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.

Component reference
A Viking 5 Series built-in freezer reports trouble through lights on its control panel and one ALARM OFF pad.
Read the definitionThe temperature sensor alarm sounds, and the display shows oPn or Shr. It is the same feature as on the refrigerator, in a freezer model.
Read the supporting manualPress the Alarm Off pad. If the display does not return to showing the temperature, get a technician to look at it promptly.
Read the supporting manualHIGH TEMP covers a refrigerator or freezer too warm for two hours. POWER flashes after a power loss with no sound. DOOR OPEN follows more than three minutes.
Read the supporting manualKeep the freezer doors closed for 24 hours or less. Beyond that, move food to a locker or use dry ice.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F21338G EN (022818) / PDF p.9
Source: the Viking 5 Series use and care manual for built-in refrigerators and freezers (form F21338G), p. 9.
Only if the freezer warms. The sensor alarm itself does not report a temperature.
On the control panel. The ALARM OFF pad stays active even when the other pads need ACTIVATE CONTROLS.
Once activated, the pads remain programmable for at least ten minutes.
After first plug-in the manual says to wait 24 hours for the cabinets to reach the factory setting of 0 F before adjusting.
Viking codes, symptoms, parts, visits
HIGH TEMP on a Viking built-in freezer is the high temperature alarm. A 5 Series lights HIGH TEMP and sounds after the freezer has been too warm for two hours; a 7 Series sounds and flashes its display. Silence it, then check the contents.
A Viking all-freezer that runs warm is often a setting or usage issue before it is a repair: a cabinet that has not settled, doors held open, a heavy load of warm food, demo mode, or a condenser needing a clean. Rule those out, then book a technician.
A Viking 5 Series built-in freezer reports trouble through lights on its control panel and one ALARM OFF pad. DOOR OPEN sounds after 3 minutes of an open door, HIGH TEMP after 2 hours of high temperature, and POWER flashes without sound after a power loss. oPn or Shr marks the temperature sensor alarm. ALARM OFF clears them.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.