Before work starts
The technician explains the work and agrees the cost with you before starting. A final figure comes after the range, oven or grill has been looked at in person.
Independent appliance repair
We repair Viking built-in and integrated all-freezer columns: a warm freezer, HIGH TEMP or POWER alarms, a door that fails to seal or a display that shows SAB or SHOW. Schedule a technician and keep the label numbers handy.


A Viking all-freezer that runs warm is often a setting or usage issue before it is a repair: a cabinet that has not settled, doors held open, a heavy load of warm food, demo mode, or a condenser needing a clean. Rule those out, then book a technician.

On a Viking all-freezer or bottom-mount unit, the guides list four reasons for little or no ice: the ice maker switched off, no water at the valve, a freezer not yet cold, or a filter limiting flow. Take them in that order, and call us if the tray stays empty.
POWER on a Viking built-in freezer shows that power was lost. A 5 Series flashes the POWER indicator without a sound and ALARM OFF clears it; a 7 Series shows a power loss on its display after a long outage and any key clears it.
SAB on a Viking built-in freezer is Sabbath mode, a setting and not an error. It disables the interior lights and the alarms. A 5 Series beeps three times and lights the code; a 7 Series lights its the code button blue.
SHOW on a Viking built-in freezer is showroom mode: the controls and interior lights work apart from the cooling system, so the freezer will not freeze. On a 5 Series three beeps sound and SHOW lights.
Shr, or oPn, on a Viking 5 Series built-in freezer is the temperature sensor alarm. The alarm sounds and the display shows oPn or Shr. Press ALARM OFF. If the display does not return to showing the temperature, book a visit.
Which part is needed gets decided on site, once the label is read and the diagnostic is done. We buy nothing in advance, and you say yes to the price before the work starts.

The condenser is the finned coil behind the kick plate that sheds heat from a Viking 7 Series integrated refrigerator. Dust and pet hair slow it down, and the temperature display blinks CL as a reminder. The 7 Series guide asks for a cleaning every 6 months by vacuuming the front of the coil.

The gaskets are the soft seals around the doors of a Viking refrigerator or freezer. The 5 Series and 7 Series guides say to clean them every three months, the way you clean the interior, and to apply a light film of petroleum jelly so they stay pliable. A dirty or stiff gasket can leave the door slightly open.
How a visit runs.
You know the plan before we arrive.

Pick the range, grill or other appliance and tell us what it does. Add the model number if you can find it.

The technician tests igniters, gas flow and controls, then talks through the findings and agrees the cost with you before any work starts.

After the repair, the technician runs the appliance through its paces and explains what changed.
HIGH TEMP, DOOR OPEN and POWER are alarm words printed in the 5 Series guide. SAB marks Sabbath mode and SHOW marks showroom mode.
Shut the door firmly, confirm the gasket sits flat, and give the unit time to come back to temperature.
Every three months with a light film of petroleum jelly, per both series guides.
SHOW is a display mode where the unit does not cool. If you see it on a unit in use, switch it off as the guide describes.
Move frozen items to a cooler if the temperature reads high for long.
HIGH TEMP stays on after the door has been shut.
The freezer cannot keep its temperature after a power cut.
The unit shows SHOW and will not leave that mode.
The gasket is torn or the door will not close flat.
Arrange a diagnosticThe technician explains the work and agrees the cost with you before starting. A final figure comes after the range, oven or grill has been looked at in person.
Anything covered by Viking's manufacturer warranty is handled by Viking itself. Our own repairs come with a warranty on the workmanship.
The compartment temperature has stayed above the set point for too long. Check the door and gasket, then book a technician if it stays.
SAB means Sabbath mode and SHOW means showroom mode. Showroom mode keeps the display on but does not cool.
5 Series built-in all-freezers and 7 Series integrated all-freezers, using the guides for those lines.
CL belongs to the 7 Series all-refrigerator in the guide we cite. Check your own display and ask us if unsure.
Inside the manufacturer’s coverage period, a repair on your Viking is theirs to handle. After it lapses, or if you favor an independent technician, schedule with us and hear the price first.
Viking codes, symptoms, parts, visits
HIGH TEMP on a Viking built-in freezer is the high temperature alarm. A 5 Series lights HIGH TEMP and sounds after the freezer has been too warm for two hours; a 7 Series sounds and flashes its display. Silence it, then check the contents.
A Viking all-freezer that runs warm is often a setting or usage issue before it is a repair: a cabinet that has not settled, doors held open, a heavy load of warm food, demo mode, or a condenser needing a clean. Rule those out, then book a technician.
The condenser is the finned coil behind the kick plate that sheds heat from a Viking 7 Series integrated refrigerator. Dust and pet hair slow it down, and the temperature display blinks CL as a reminder. The 7 Series guide asks for a cleaning every 6 months by vacuuming the front of the coil.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.