Inside the appliance
Baffle filters. In plain English.
Viking professional wall hoods use stainless steel baffle filters, which trap grease in U-shaped channels. The 18-inch hood guide says to examine them periodically and wash them in a dishwasher or a sink with hot soapy water. Do not use caustic detergent, and do not take the filters apart.

Where it fits.
Baffle filters in the appliance
Inside the underside of the hood, over the cooking surface.
The photo shows the kind of component. It cannot tell you which replacement fits your series.
The signs that this system wants attention.
Baffle filters trouble can turn up together with a drop in performance or a code that keeps coming back. Testing is required before anyone decides this component is to blame.

Viking hood not pulling smoke or steam
A Viking hood that lets smoke and steam escape is usually clogged filters, too low a fan speed, a draft across the cooktop or a charcoal filter past its life. Clean the grease filters, raise the speed and replace a recirculating charcoal filter. Book a technician if the airflow stays weak.

Viking hood shuts off or ignores the remote
A Viking Pureline Pro ceiling hood can stop for four reasons the guide names: the motor’s thermal switch, the 3-hour auto-stop, the 10-minute run-on and a remote that lost its code after a power cut. Wait 3 minutes after power returns, then try the remote again. Call us if it keeps stopping.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any check you can make yourself. Beware of standing water and sharp edges. Never touch a wet plug or live wiring, take off service panels, or go beyond what your series' guide allows.
- 1
Switch off and unplug
The guide says to unplug the cords from the control panel before cleaning or servicing the hood.
- 2
Slide the filter out
Slide it forward off the rear lip, lower the rear, then slide the front out.
- 3
Wash by hand or dishwasher
Hot soapy water or the dishwasher. No caustic detergent, abrasive or corrosive cleaner.
- 4
Do not take it apart
The guide says it is not necessary and will void the filter warranty.
Cleaning or replacement?
Leave internal testing to a technician.
Grease drips from the filter area after cleaning.
A filter is bent and will not seat on its lip.
The blower runs but suction is weak with clean filters.
Arrange a diagnosticSources and model boundaries.
The Baffle filters guidance rests on these references. Choose the manual that fits your own series.
- Use & Care / Professional Indoor & Outdoor Hoods / VWH53012 / VWH53612 / VWH53048 / VWH53648 / VWH54248
Rely on the guide for your precise series, and read how we research these pages.
How do I clean the filters on a Viking wall hood?
Slide each baffle filter out, wash it in hot soapy water or a dishwasher, dry it and slide it back onto its lip. Do not disassemble it.
What cleaners are off limits?
Caustic detergent and abrasive or corrosive cleaners, since they may damage the finish.
Is there a grease trough?
On the 18-inch models, yes. The guide says to remove the grease trough and soak it in hot soapy water when you clean the filters.
Is there a cleaning interval?
The guide says to examine them periodically and gives no fixed interval. A technician can check the blower if suction stays weak.
Viking codes, symptoms, parts, visits
From the message to your next move.
Viking hood not pulling smoke or steam
A Viking hood that lets smoke and steam escape is usually clogged filters, too low a fan speed, a draft across the cooktop or a charcoal filter past its life. Clean the grease filters, raise the speed and replace a recirculating charcoal filter. Book a technician if the airflow stays weak.
Hood repair
Book a diagnostic for your series at the appliance itself.
Find your metro
Office particulars and the entry details to give us.

