What it means
2-4 means the POTS/PANS light flashes twice and the NORMAL WASH light flashes four times. Viking's chart calls it High Level Error and lists one check: items in the rack must be held so they cannot turn over.
Viking dishwasher 2-4 / Flash pairs
2-4 means the POTS/PANS light flashes twice and the NORMAL WASH light flashes four times. Viking's chart calls it High Level Error and lists one check: items in the rack must be held so they cannot turn over.
Also shown as 2-4
2-4 means the POTS/PANS light flashes twice and the NORMAL WASH light flashes four times. Viking's chart calls it High Level Error and lists one check: items in the rack must be held so they cannot turn over.
Make sure items are retained so they cannot turn over.
2-4 flashes again after the reset.
Your Viking checklist, kept on this device only

Make sure items are retained so they cannot turn over.

Hold START for 4 seconds.

Watch for the pair.

If it returns.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visit
A simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.

Component reference
A Viking 451 or 324 Series dishwasher watches the water level in the tub.
Read the definitionHigh Level Error, with one check: verify that items in the rack are properly retained so that they cannot turn over. Then reset and try again.
Read the supporting manual2-3 is the Low Level Sensor Error, with its extra drain hose check. 1-5 is the Drain Error and has six checks, including filters and the garbage disposal plug. 2-4 has the shortest list of the three.
Read the supporting manualThe manual does not explain the mechanism. It states the check without a cause, so the rack check is the only owner step with a printed basis.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20879C EN (022213) / PDF p.19
Manufacturer document
Viking Range, LLC (official manual PDF)
form F21216 EN (060113) / PDF p.18
Sources: the Viking 451 Series (p. 19) and 324 Series (p. 18) built-in dishwasher manuals; both print the same flash chart.
The check is that nothing can tip over. Reseat anything light, such as plastic cups, so water does not pool in them.
The chart does not say. If you see standing water, the drain checks in the 1-5 row are the ones with a printed list.
The water level sensors, since the label names a level error. That link is background, not a diagnosis.
Holding START for four seconds cancels the current selection, per the manual. Pick the cycle again and close the door within four seconds.
Viking codes, symptoms, parts, visits
2-1 means the POTS/PANS light flashes twice and the NORMAL WASH light flashes once. Viking's chart calls it Huba Disconnect Error and prints only a reset.
A Viking dishwasher that leaves dishes dirty or cloudy is, per Viking's chart, mostly a loading, detergent or filter matter. Check the filters and strainer first, then the wash arms, rinse agent and detergent amount. Odor and slow drying have their own entries, covered below.
A Viking 451 or 324 Series dishwasher watches the water level in the tub. A Low Level Sensor Error is 2 flashes of POTS/PANS then 3 of NORMAL WASH, and a High Level Error is 2 then 4. The chart lists dishes tipped over and holding water, the drain hose loop, and loose items in the racks.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.