What it means
2-3 means the POTS/PANS light flashes twice and the NORMAL WASH light flashes three times. Viking's chart calls it Low Level Sensor Error and lists two checks: dishes holding water, and the drain hose high loop.
Viking dishwasher 2-3 / Flash pairs
2-3 means the POTS/PANS light flashes twice and the NORMAL WASH light flashes three times. Viking's chart calls it Low Level Sensor Error and lists two checks: dishes holding water, and the drain hose high loop.
Also shown as 2-3
2-3 means the POTS/PANS light flashes twice and the NORMAL WASH light flashes three times. Viking's chart calls it Low Level Sensor Error and lists two checks: dishes holding water, and the drain hose high loop.
Make sure no dishes have turned over and hold a lot of water.
2-3 flashes again after the reset.
Your Viking checklist, kept on this device only

Make sure no dishes have turned over and hold a lot of water.

The drain hose should have a high loop per the installation guide.

Hold START for 4 seconds.

If it returns after the checks.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visit
A simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.

Component reference
The drain hose carries wash water out of a Viking built-in dishwasher toward the plumbing under your sink.
Read the definition
Component reference
A Viking 451 or 324 Series dishwasher watches the water level in the tub.
Read the definitionLow Level Sensor Error, with two checks: that no dishes have turned over and are holding a significant amount of water, and that the drain hose has a high loop as the installation guide shows.
Read the supporting manual2-4 is High Level Error and its only check is that items in the rack cannot turn over. 2-3 adds the drain hose loop.
Read the supporting manualThe chart lists it as a check and does not explain why. The part pages in this site cover the drain hose and the water level sensors for that reason.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20879C EN (022213) / PDF p.19
Manufacturer document
Viking Range, LLC (official manual PDF)
form F21216 EN (060113) / PDF p.18
Sources: the Viking 451 Series (p. 19) and 324 Series (p. 18) built-in dishwasher manuals; both print the same flash chart.
The chart says dishes that have turned over. Our general note: cups and bowls loaded face-up catch water. The manual does not name particular items.
The chart points to the installation guide for it. If you cannot see the hose route without pulling the dishwasher out, leave that to a visit.
The label says Low Level Sensor Error, but the two checks point at water held in dishes and the hose route. A broken sensor is not confirmed by the chart.
Dishes first, then the hose loop, then the reset. That follows the order the chart prints them.
Viking codes, symptoms, parts, visits
2-1 means the POTS/PANS light flashes twice and the NORMAL WASH light flashes once. Viking's chart calls it Huba Disconnect Error and prints only a reset.
A Viking dishwasher that leaves dishes dirty or cloudy is, per Viking's chart, mostly a loading, detergent or filter matter. Check the filters and strainer first, then the wash arms, rinse agent and detergent amount. Odor and slow drying have their own entries, covered below.
The drain hose carries wash water out of a Viking built-in dishwasher toward the plumbing under your sink. The 451 Series chart lists a clogged or kinked hose when the machine will not drain, and asks for a cone fitting cut to an inner diameter of at least 3/4 inch. The 324 Series chart adds a high loop.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.