What it means
2-2 means the POTS/PANS light flashes twice and the NORMAL WASH light flashes twice. Viking's chart calls it Fill Timeout and lists four checks: supply on, fill line not kinked, dishwasher level, and water pressure at the sink.
Viking dishwasher 2-2 / Flash pairs
2-2 means the POTS/PANS light flashes twice and the NORMAL WASH light flashes twice. Viking's chart calls it Fill Timeout and lists four checks: supply on, fill line not kinked, dishwasher level, and water pressure at the sink.
Also shown as 2-2
2-2 means the POTS/PANS light flashes twice and the NORMAL WASH light flashes twice. Viking's chart calls it Fill Timeout and lists four checks: supply on, fill line not kinked, dishwasher level, and water pressure at the sink.
Verify the water supply to the dishwasher is turned on.
2-2 flashes again after the reset.
Your Viking checklist, kept on this device only

Verify the water supply to the dishwasher is turned on.

Make sure it is not kinked.

The dishwasher should be level front to back and side to side.

Turn water on at the sink and see whether pressure has dropped; then reset.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visit
A simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.
The dishwasher did not reach its water level within the allowed time.
Read the supporting manualThose report water filling too fast. 2-2 reports too slow or none.
Read the supporting manualReset by holding START for 4 seconds and try again.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20879C EN (022213) / PDF p.19
Manufacturer document
Viking Range, LLC (official manual PDF)
form F21216 EN (060113) / PDF p.18
Sources: the Viking 451 Series (p. 19) and 324 Series (p. 18) built-in dishwasher manuals; both print the same flash chart.
Yes; that is the first check.
The chart lists a drop in pressure as a check.
The chart lists it.
If the pair returns after the checks.
Viking codes, symptoms, parts, visits
2-1 means the POTS/PANS light flashes twice and the NORMAL WASH light flashes once. Viking's chart calls it Huba Disconnect Error and prints only a reset.
A Viking dishwasher that leaves dishes dirty or cloudy is, per Viking's chart, mostly a loading, detergent or filter matter. Check the filters and strainer first, then the wash arms, rinse agent and detergent amount. Odor and slow drying have their own entries, covered below.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.