What it means
4-1 means the POTS/PANS light flashes four times and the NORMAL WASH light flashes once. Viking's chart calls it Temperature Sensor Error and prints only a reset.
Viking dishwasher 4-1 / Flash pairs
4-1 means the POTS/PANS light flashes four times and the NORMAL WASH light flashes once. Viking's chart calls it Temperature Sensor Error and prints only a reset.
Also shown as 4-1
4-1 means the POTS/PANS light flashes four times and the NORMAL WASH light flashes once. Viking's chart calls it Temperature Sensor Error and prints only a reset.
Four, then one.
4-1 flashes again after the reset.
Your Viking checklist, kept on this device only

Four, then one.

Hold START for 4 seconds.

Watch for the pair.

No checks are listed.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visit
A simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.
Temperature Sensor Error, with a reset as the only action. The label names the sensor but the chart does not say where it sits.
Read the supporting manual4-2 on the 451 Series and 4-5 on the 324 Series is Fill Too Fast Error, which has a level check. 4-1 has no check at all.
Read the supporting manualIt recommends an incoming temperature of 120°F (49°C) and says the Sure Temp Water Heating System ensures temperatures are correct for the cycle and options chosen.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20879C EN (022213) / PDF p.19
Manufacturer document
Viking Range, LLC (official manual PDF)
form F21216 EN (060113) / PDF p.18
Sources: the Viking 451 Series (p. 19) and 324 Series (p. 18) built-in dishwasher manuals; both print the same flash chart.
The manual says cold water only lengthens the cycle, because the dishwasher takes longer to heat it. It does not link cold water to 4-1.
Not necessarily. The manual says that light stays off if the cycle is interrupted or the water could not reach temperature.
The chart does not rate it. After one reset and one clean run, a repeat of the same pair means book a visit.
HI TEMP WASH and SANITIZED 155°F RINSE. The manual does not say they trigger 4-1.
Viking codes, symptoms, parts, visits
4-2 means the POTS/PANS light flashes four times and the NORMAL WASH light flashes twice. On the 451 Series chart, Viking calls it Fill Too Fast Error: check that the dishwasher is level front to back and side to side, then reset.
A Viking dishwasher that leaves dishes dirty or cloudy is, per Viking's chart, mostly a loading, detergent or filter matter. Check the filters and strainer first, then the wash arms, rinse agent and detergent amount. Odor and slow drying have their own entries, covered below.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.