What it means
4-5 means the POTS/PANS light flashes four times and the NORMAL WASH light flashes five times. On the 324 Series chart, Viking calls it Fill Too Fast Error: check the dishwasher is level front to back and side to side, then reset.
Viking dishwasher 4-5 / Flash pairs
4-5 means the POTS/PANS light flashes four times and the NORMAL WASH light flashes five times. On the 324 Series chart, Viking calls it Fill Too Fast Error: check the dishwasher is level front to back and side to side, then reset.
Also shown as 4-5
4-5 means the POTS/PANS light flashes four times and the NORMAL WASH light flashes five times. On the 324 Series chart, Viking calls it Fill Too Fast Error: check the dishwasher is level front to back and side to side, then reset.
Front to back and side to side.
4-5 flashes again after the reset.
Your Viking checklist, kept on this device only

Front to back and side to side.

Hold START for 4 seconds.

Watch for the pair.

If it returns.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visit
A simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.
Fill Too Fast Error on the 324 Series chart. The step is to verify the dishwasher is level front to back and side to side, reset the unit and try again.
Read the supporting manualThe 451 Series chart prints the same label as 4-2. The 324 Series has no 4-2 row at all, so 4-5 is the only fill-speed row you will see.
Read the supporting manual2-2 is Fill Timeout with four supply checks. 4-5 shares only the level check with it. The 4-5 row does not ask you to look at the supply valve or fill line.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20879C EN (022213) / PDF p.19
Manufacturer document
Viking Range, LLC (official manual PDF)
form F21216 EN (060113) / PDF p.18
Source: the Viking 324 Series built-in dishwasher manual, p. 18.
The row lists no supply check. Fill Timeout, 2-2, is the row that asks about the water supply, kinked fill line and pressure.
The chart gives no method for leveling. If you cannot confirm it from the open door, book a visit.
Yes, Fill Too Fast Error, but only the 451 Series calls it 4-2.
Yes, holding START four seconds resets it. The beeps for error messages cannot otherwise be switched off.
Viking codes, symptoms, parts, visits
4-2 means the POTS/PANS light flashes four times and the NORMAL WASH light flashes twice. On the 451 Series chart, Viking calls it Fill Too Fast Error: check that the dishwasher is level front to back and side to side, then reset.
A Viking dishwasher that leaves dishes dirty or cloudy is, per Viking's chart, mostly a loading, detergent or filter matter. Check the filters and strainer first, then the wash arms, rinse agent and detergent amount. Odor and slow drying have their own entries, covered below.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.