What it means
5-5 means the POTS/PANS light flashes five times and the NORMAL WASH light flashes five times. Viking's chart calls it Internal Error and prints only a reset.
Viking dishwasher 5-5 / Flash pairs
5-5 means the POTS/PANS light flashes five times and the NORMAL WASH light flashes five times. Viking's chart calls it Internal Error and prints only a reset.
Also shown as 5-5
5-5 means the POTS/PANS light flashes five times and the NORMAL WASH light flashes five times. Viking's chart calls it Internal Error and prints only a reset.
Five, then five.
5-5 flashes again after the reset.
Your Viking checklist, kept on this device only

Five, then five.

Hold START for 4 seconds.

Watch for the pair.

No checks are listed.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visit
A simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.
Internal Error, with only a reset. It is the last numbered row of the chart.
Read the supporting manualPan Flood has no flash count. Per Note A both lights flash continuously. 5-5 is five flashes of POTS/PANS and five of NORMAL WASH, so count first.
Read the supporting manualThe five-year limited warranty names electronic controls, with the fourth and fifth year repairs free of charge for the part only, the owner paying other costs. The chart does not say 5-5 is a control failure.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20879C EN (022213) / PDF p.19
Manufacturer document
Viking Range, LLC (official manual PDF)
form F21216 EN (060113) / PDF p.18
Sources: the Viking 451 Series (p. 19) and 324 Series (p. 18) built-in dishwasher manuals; both print the same flash chart.
The chart does not say that. Internal Error is the label, with a reset as its action.
The reset is the chart's own step: hold START for four seconds.
The manual does not rate any code. A repeat after reset is the point to book a visit.
3-1 is a communication error between two named blocks. 5-5 names nothing.
Viking codes, symptoms, parts, visits
PAN FLOOD on a Viking built-in dishwasher is shown by both lights, POTS/PANS and NORMAL WASH, flashing continuously. Viking prints only a reset: hold START for 4 seconds. If water reaches the floor, shut the supply valve and book a technician.
A Viking dishwasher that leaves dishes dirty or cloudy is, per Viking's chart, mostly a loading, detergent or filter matter. Check the filters and strainer first, then the wash arms, rinse agent and detergent amount. Odor and slow drying have their own entries, covered below.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.