Inside the appliance
Drain pump and drain lamp. In plain English.
A Viking 5 Series nugget ice machine (FNIU515D) removes melt water with a drain pump that has its own reservoir. The pump turns on by itself as the reservoir fills, even in Sabbath mode. The Drain lamp lights when the drain valve opens, and Er16 means the water level sensor was not reached within 2 minutes of draining.

Where it fits.
Drain pump and drain lamp in the appliance
At the back of the machine, with the drain hose secured to the rear panel.
The photo shows the kind of component. It cannot tell you which replacement fits your series.
The signs that this system wants attention.
Drain pump and drain lamp trouble can turn up together with a drop in performance or a code that keeps coming back. Testing is required before anyone decides this component is to blame.

Viking ice maker not making ice
On a Viking undercounter ice machine, little or no ice usually traces to the control position, the water supply, a blocked drain, a dirty condenser or scale on the evaporator. Check the switch and the water first, then clean the system. Book a technician if the bin stays empty.

Viking ice maker ice smells or tastes off
Gray, smelly or off-tasting ice from a Viking ice machine usually means mineral scale on the evaporator, hard water, food stored in the bin or an old charcoal filter. Clean the machine, empty the bin of anything but ice and consider a filter. Call us if the taste stays after cleaning.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any check you can make yourself. Beware of standing water and sharp edges. Never touch a wet plug or live wiring, take off service panels, or go beyond what your series' guide allows.
- 1
Check the hose
The drain hose must be secured to the back panel. Do not pull or bend it, because that can damage the pump.
- 2
Mind the lift
The guide gives a maximum lift of 10 feet for the pump.
- 3
Read the Drain lamp
It lights when the drain valve is operating. A blinking Drain lamp is the Er16 pattern in the troubleshooting table.
- 4
Clear the bin
Water in the bin points to a clogged bin drain. The guide says to clean the mesh at the bottom of the bin.
Cleaning or replacement?
Leave internal testing to a technician.
Er16 returns after power is cycled.
Water pools in the bin or under the machine.
The pump runs constantly or never runs.
Arrange a diagnosticSources and model boundaries.
The Drain pump and drain lamp guidance rests on these references. Choose the manual that fits your own series.
- Install / Use & Care MANUAL / Undercounter Nugget Ice Machine / FNIU515D
Rely on the guide for your precise series, and read how we research these pages.
Does a Viking nugget ice machine need a drain pump?
The FNIU515D guide describes a drain pump with a reservoir that clears waste water and a hookup that allows a maximum lift of 10 feet.
What does the Drain lamp mean?
It lights when the drain valve is activated.
What is Er16?
A water drain error: the lower limit water level was not detected within 2 minutes while the drain valve operated.
Does Sabbath mode stop the pump?
No. The pump keeps removing waste water, and ice keeps being made.
Viking codes, symptoms, parts, visits
From the message to your next move.
Er16
Er16 on a Viking FNIU515D nugget ice machine is a water drain error: the lower limit water level sensor did not detect water within 2 minutes of the drain valve operating. The chart lists replacing the sensor and checking the drain valve.
Viking ice maker not making ice
On a Viking undercounter ice machine, little or no ice usually traces to the control position, the water supply, a blocked drain, a dirty condenser or scale on the evaporator. Check the switch and the water first, then clean the system. Book a technician if the bin stays empty.
Ice maker repair
Book a diagnostic for your series at the appliance itself.
Find your metro
Office particulars and the entry details to give us.
