Inside the appliance
Filters and the coarse strainer. In plain English.
A Viking 451 or 324 Series dishwasher keeps a coarse strainer, a fine filter and a primary filter in its base, under the lower rack. Viking says never to run the machine without the filters in place. You lift out and empty the strainer, can twist out the fine filter, and should leave the primary filter alone.

Where it fits.
Filters and the coarse strainer in the appliance
Down in the wash basin beneath the lower rack, where used water gathers.
The photo shows the kind of component. It cannot tell you which replacement fits your series.
The signs that this system wants attention.
Filters and the coarse strainer trouble can turn up together with a drop in performance or a code that keeps coming back. Testing is required before anyone decides this component is to blame.

Viking dishwasher controls not responding
On a Viking 451 or 324 Series dishwasher, a dark panel is often normal: cycle and option buttons only light after you select them. Select START, shut the door inside 4 seconds, and the cycle begins. If the lights flash instead, use the reset: hold START for 4 seconds.

Viking dishwasher leaking
The Viking dishwasher manuals print no leak entry in their troubleshooting chart. What they do print is PAN FLOOD: both cycle lights flash continuously, and the chart's only action is to reset by holding START for 4 seconds. Water on the floor calls for the supply shut and a visit, not repeated resets.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any check you can make yourself. Beware of standing water and sharp edges. Never touch a wet plug or live wiring, take off service panels, or go beyond what your series' guide allows.
- 1
Lift out the strainer
Squeeze the tabs on the coarse strainer, lift it out and empty it. Viking says some water standing in that area is normal.
- 2
Twist the fine filter
If it needs cleaning, rotate it out and soak it overnight in a 50/50 water and vinegar mix, or a citric cleaner.
- 3
Leave the primary filter
The guides print DO NOT remove primary filter next to the drawing.
- 4
Seat everything back
Put each filter back and secure it before the next cycle. The warnings say never to operate the dishwasher without them.
Cleaning or replacement?
Leave internal testing to a technician.
Dishes stay gritty once the filters are clean and in place.
Water stays in the tub well after the cycle ends and the drain hose is clear.
A filter is cracked or will not lock back in place.
Arrange a diagnosticSources and model boundaries.
The Filters and the coarse strainer guidance rests on these references. Choose the manual that fits your own series.
- Viking Use & Care Manual / 451 Series Built-In Dishwashers
- Use & Care / 324 Series Built-In Dishwashers
Rely on the guide for your precise series, and read how we research these pages.
Where are the filters in a Viking dishwasher?
In the base of the wash basin. The guides show a coarse strainer, a fine filter and a primary filter you should not remove.
How often do they need cleaning?
Under normal use they are self cleaning. With heavy soil, sediment or hard water the guides say you may need to clean them after each use.
Is it normal for water to sit near the filters?
A small amount remaining in the coarse strainer area is normal, Viking says. Standing water elsewhere points to the drain, so check the hose and book a visit.
Can I run the machine without the filters?
No. Both guides warn against running the dishwasher without the filters in place.
Viking codes, symptoms, parts, visits
From the message to your next move.
PAN FLOOD
PAN FLOOD on a Viking built-in dishwasher is shown by both lights, POTS/PANS and NORMAL WASH, flashing continuously. Viking prints only a reset: hold START for 4 seconds. If water reaches the floor, shut the supply valve and book a technician.
Viking dishwasher not cleaning well
A Viking dishwasher that leaves dishes dirty or cloudy is, per Viking's chart, mostly a loading, detergent or filter matter. Check the filters and strainer first, then the wash arms, rinse agent and detergent amount. Odor and slow drying have their own entries, covered below.
Dishwasher repair
Book a diagnostic for your series at the appliance itself.
Find your metro
Office particulars and the entry details to give us.
