What it means
RTD ERROR on a Viking touch-control wall oven means the RTD is open or shorted. RTD is the printed label; Viking does not expand it. The table lists no step for you except a service call, so book a visit.
Viking range RTD ERROR / Display message
RTD ERROR on a Viking touch-control wall oven means the RTD is open or shorted. RTD is the printed label; Viking does not expand it. The table lists no step for you except a service call, so book a visit.
Also shown as RTD ERROR
RTD ERROR on a Viking touch-control wall oven means the RTD is open or shorted. RTD is the printed label; Viking does not expand it. The table lists no step for you except a service call, so book a visit.
See whether the message clears.
RTD ERROR returns after you press OFF and start again.
Your Viking checklist, kept on this device only

See whether the message clears.

Let it cool.

Copy it exactly.

A technician checks the sensor.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visitA simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.
RTD ERROR: "RTD is open or shorted." The correction column says to call for service, which for you means booking a visit. RTD is not expanded anywhere in the manual.
Read the supporting manualThe tone table pairs an RTD error with the Failure signal: five tones, each 1 second long. Latch errors use the same signal, so the sound alone does not tell you which one it is.
Read the supporting manualPROBE ERROR can be cleared by plugging the probe in and pressing OFF. RTD ERROR carries no such step: only the call to service.
Read the supporting manualThe table does not say. The one general instruction is to check whether the circuit breaker is open or a fuse blown when the oven fails to operate.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20813D EN (040116) / PDF p.34
Manufacturer document
Viking Range, LLC (official manual PDF)
form F20366F EN (071309J) / PDF p.29
Sources: the Viking Professional Built-In Electric Touch Control Single and Double Oven manual (p. 34) and the Professional and Designer Series manual (p. 29).
No. The meat probe has its own PROBE ERROR row. The manual does not say where the RTD sits.
The manual only lists the signal for RTD and latch errors. It does not rate the severity.
The table lists OFF only for PROBE ERROR. For RTD ERROR it lists the service call alone.
The message text, whether you heard the five tones, the model and the serial number.
Viking codes, symptoms, parts, visits
PROBE ERROR on a Viking touch-control wall oven means the meat probe is open or shorted. The probe may simply be unplugged: plug it in, or press OFF to clear the message. If the probe is plugged in and the message stays, book a visit.
A Viking range burner that will not light usually comes down to power, the gas valve, or a dirty igniter. Viking's printed table separates the causes by what you see: no spark, spark but no flame, endless sparking, or a yellow flame. With a gas smell, leave the knobs alone and phone your gas supplier.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.