What it means
MODEL ERROR on a Viking touch-control wall oven says an incorrect model number has been installed. Viking's table tells you to call a service agency. Write the message down and book a visit.
Viking range MODEL ERROR / Display message
MODEL ERROR on a Viking touch-control wall oven says an incorrect model number has been installed. Viking's table tells you to call a service agency. Write the message down and book a visit.
Also shown as MODEL ERROR
MODEL ERROR on a Viking touch-control wall oven says an incorrect model number has been installed. Viking's table tells you to call a service agency. Write the message down and book a visit.
Copy it exactly.
MODEL ERROR returns after you press OFF and start again.
Your Viking checklist, kept on this device only

Copy it exactly.

Note the model and serial numbers.

The table lists none.

A control with the wrong model setting needs a technician.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visitA simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.
MODEL ERROR: "An incorrect model number has been installed." The correction column says to call for service, which for you means booking a visit.
Read the supporting manualIt is listed first in the Error Handling table, ahead of RTD ERROR, PROBE ERROR, LATCH ERROR and KEYBOARD ERROR. The section is introduced as a key for correcting programming errors, but MODEL ERROR is not something you can correct by programming.
Read the supporting manualThe service information page lists the model number, serial number, date purchased and the dealer's name. Having those to hand makes the report precise.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20813D EN (040116) / PDF p.34
Manufacturer document
Viking Range, LLC (official manual PDF)
form F20366F EN (071309J) / PDF p.29
Sources: the Viking Professional Built-In Electric Touch Control Single and Double Oven manual (p. 34) and the Professional and Designer Series manual (p. 29).
The table talks about a model number installed in the control. The sticker and the stored value are different things, and the manual does not say how they are compared.
The manual does not link it to a power cut. The one power note is a general check of the circuit breaker or fuse.
The tone table has no entry for MODEL ERROR. Only a long beep before any programming error message is described.
The Professional built-in electric touch control single and double ovens (F20813) and the Professional and Designer series (F20366) both print it.
Viking codes, symptoms, parts, visits
RTD ERROR on a Viking touch-control wall oven means the RTD is open or shorted. RTD is the printed label; Viking does not expand it. The table lists no step for you except a service call, so book a visit.
A Viking range burner that will not light usually comes down to power, the gas valve, or a dirty igniter. Viking's printed table separates the causes by what you see: no spark, spark but no flame, endless sparking, or a yellow flame. With a gas smell, leave the knobs alone and phone your gas supplier.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.