What it means
KEYBOARD ERROR on a Viking touch-control wall oven means there is no connection between the keyboard and the control. The table lists a service call. Switch the oven's breaker off if you want it idle, then book a visit.
Viking range KEYBOARD ERROR / Display message
KEYBOARD ERROR on a Viking touch-control wall oven means there is no connection between the keyboard and the control. The table lists a service call. Switch the oven's breaker off if you want it idle, then book a visit.
Also shown as KEYBOARD ERROR
KEYBOARD ERROR on a Viking touch-control wall oven means there is no connection between the keyboard and the control. The table lists a service call. Switch the oven's breaker off if you want it idle, then book a visit.
See whether the message clears.
KEYBOARD ERROR returns after you press OFF and start again.
Your Viking checklist, kept on this device only

See whether the message clears.

Try one program.

Switch the breaker off if it misbehaves.

No owner steps are listed.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visitA simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.
KEYBOARD ERROR is listed with the problem "No connection exists between the keyboard and control" and one correction: a service call.
Read the supporting manualThe manual says a programming error brings a long beep, then the message on the display. The five-tone Failure signal is listed only for RTD or latch errors, so a keyboard message arrives without it.
Read the supporting manualMODEL ERROR and RTD ERROR name the control's model setting and a sensor. LATCH ERROR names the door latch. PROBE ERROR is the one with a self-clearing step. KEYBOARD ERROR is about the link between the keys and the control.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20813D EN (040116) / PDF p.34
Manufacturer document
Viking Range, LLC (official manual PDF)
form F20366F EN (071309J) / PDF p.29
Sources: the Viking Professional Built-In Electric Touch Control Single and Double Oven manual (p. 34) and the Professional and Designer Series manual (p. 29).
The table does not give a cause. It prints the problem as no connection between keyboard and control and sends you to service.
It says that if the oven fails to operate you should check whether the circuit breaker is open or the fuse blown. That is a general power check, not a KEYBOARD ERROR fix.
The tone table lists Failure (5 tones, 1 second each) for RTD or latch errors, and 3 short tones for Invalid Entry or Invalid Key. It does not list a tone for KEYBOARD ERROR.
The manual does not say. With no link between keys and control, expect the keypad not to respond.
Viking codes, symptoms, parts, visits
LATCH ERROR on a Viking touch-control wall oven means the control cannot lock or unlock the door latch. The table lists a service call and no reset. Do not force the door; book a visit.
A Viking range burner that will not light usually comes down to power, the gas valve, or a dirty igniter. Viking's printed table separates the causes by what you see: no spark, spark but no flame, endless sparking, or a yellow flame. With a gas smell, leave the knobs alone and phone your gas supplier.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.