Inside the appliance
Condenser, grille and CHECK COND.. In plain English.
A Viking FDWCIC7240 wine column dumps heat through a condenser behind the lower front ventilation grille. The display asks for a cleaning with CHECK COND. every 6 months. Vacuum the vent slits with a soft brush, then clear the reminder with the RESET icon, or by holding ENTER for 5 seconds as the message table says.

Where it fits.
Condenser, grille and CHECK COND. in the appliance
Behind the grille you can lift off below the door.
The photo shows the kind of component. It cannot tell you which replacement fits your series.
The signs that this system wants attention.
Condenser, grille and CHECK COND. trouble can turn up together with a drop in performance or a code that keeps coming back. Testing is required before anyone decides this component is to blame.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any check you can make yourself. Beware of standing water and sharp edges. Never touch a wet plug or live wiring, take off service panels, or go beyond what your series' guide allows.
- 1
Vacuum the grille slits
Use a vacuum cleaner with a soft brush attachment at maximum power, sweeping along the vent slits.
- 2
Remove the grille for dust build-up
Switch the column off with ON/OFF held for about 3 seconds and wait about 30 minutes for the condenser to cool. Take off the grille beneath the door.
- 3
Protect your hands
The condenser edges are sharp. The guide asks for hand and arm protection while you clean.
- 4
Reset the reminder
After cleaning, touch RESET to restart the 6-month signal, or hold ENTER for 5 seconds on the message.
Cleaning or replacement?
Leave internal testing to a technician.
CHECK COND. returns soon after a thorough clean.
Upper too warm or Lower too warm persists once the condenser is clean and the vents are open.
Arrange a diagnosticSources and model boundaries.
The Condenser, grille and CHECK COND. guidance rests on these references. Choose the manual that fits your own series.
- User Guide, FDWCIC7240 7 Series Integrated Wine Column
Rely on the guide for your precise series, and read how we research these pages.
How often does CHECK COND. appear?
Every 6 months, per the care chapter and the message table. The maintenance page of the same guide mentions 12 months, so follow the display.
Where is the condenser?
Behind the lower front ventilation grille, below the door.
Is CHECK COND. a breakdown?
No. It is a cleaning reminder. Clean the condenser and reset it.
Can I switch off the reminder?
Yes. The guide says touching the OFF icon stops the warning signal for the condenser.
Viking codes, symptoms, parts, visits
From the message to your next move.
Check condenser
Check condenser, shown as CHECK COND., appears every 6 months on a Viking FDWCIC7240 wine column. Clean the condenser and press and hold ENTER for 5 seconds to reset it. It is upkeep, not a breakdown.
Viking wine cooler not cold enough
A Viking wine cooler that runs warm is usually a control set too warm, a load that has not stabilized, a blocked front grille or a door gasket that is not sealing. Allow 24 hours after any change, clear the grille and check the gasket. Book a technician if it stays warm.
Wine cellar repair
Book a diagnostic for your series at the appliance itself.
Find your metro
Office particulars and the entry details to give us.


