What it means
1-4 means the POTS/PANS light flashes once and the NORMAL WASH light flashes four times. Viking's chart calls it Diverter Timeout and prints only a reset.
Viking dishwasher 1-4 / Flash pairs
1-4 means the POTS/PANS light flashes once and the NORMAL WASH light flashes four times. Viking's chart calls it Diverter Timeout and prints only a reset.
Also shown as 1-4
1-4 means the POTS/PANS light flashes once and the NORMAL WASH light flashes four times. Viking's chart calls it Diverter Timeout and prints only a reset.
One, then four.
1-4 flashes again after the reset.
Your Viking checklist, kept on this device only

One, then four.

Hold START for 4 seconds.

Check whether water reaches the sprays.

No owner checks are listed.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visit
A simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.
Diverter Timeout, with only a reset as its action. The diverter is also named in the warranty section, in the list of motor/pump and water distribution components.
Read the supporting manual2-1 is Huba Disconnect Error and 2-2 is Fill Timeout, which comes with four water-supply checks. 1-4 has none of those checks, only the reset.
Read the supporting manualThe manual's poor-results table says to check that both wash arms rotate freely. It is listed for dishes that stay dirty, not for 1-4, so treat it as general care.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20879C EN (022213) / PDF p.19
Manufacturer document
Viking Range, LLC (official manual PDF)
form F21216 EN (060113) / PDF p.18
Sources: the Viking 451 Series (p. 19) and 324 Series (p. 18) built-in dishwasher manuals; both print the same flash chart.
The manuals name the part but do not describe its job. Nothing printed explains how it directs water, so we do not guess at it.
The warranty lists the diverter among the motor/pump and water distribution components in the fourth and fifth years. Read the full terms on your unit's warranty before relying on that.
No. The manual's wash-arm check is for cleaning results. The only reset it prints for an error is holding START for four seconds.
The chart lists numbered checks only for Drain Error, Fill Timeout, the two level errors and Fill Too Fast. Every other row, including this one, gets the reset alone.
Viking codes, symptoms, parts, visits
1-1 means the POTS/PANS light flashes once and the NORMAL WASH light flashes once. Viking's chart calls it Pan Flood Sensor Disconnect and prints only a reset: hold START for 4 seconds.
A Viking dishwasher that leaves dishes dirty or cloudy is, per Viking's chart, mostly a loading, detergent or filter matter. Check the filters and strainer first, then the wash arms, rinse agent and detergent amount. Odor and slow drying have their own entries, covered below.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.