What it means
1-1 means the POTS/PANS light flashes once and the NORMAL WASH light flashes once. Viking's chart calls it Pan Flood Sensor Disconnect and prints only a reset: hold START for 4 seconds.
Viking dishwasher 1-1 / Flash pairs
1-1 means the POTS/PANS light flashes once and the NORMAL WASH light flashes once. Viking's chart calls it Pan Flood Sensor Disconnect and prints only a reset: hold START for 4 seconds.
Also shown as 1-1
1-1 means the POTS/PANS light flashes once and the NORMAL WASH light flashes once. Viking's chart calls it Pan Flood Sensor Disconnect and prints only a reset: hold START for 4 seconds.
One flash, a pause, one flash.
1-1 flashes again after the reset.
Your Viking checklist, kept on this device only

One flash, a pause, one flash.

Hold START for 4 seconds.

See whether the pair returns.

The chart gives no owner checks for this pair, so a repeat needs a technician.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visit
A simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.
The pan flood sensor, according to the chart label. It names no further detail.
Read the supporting manualPAN FLOOD is both lights flashing continuously. 1-1 is a single flash on each light.
Read the supporting manualThe label speaks of a disconnect, not of water.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20879C EN (022213) / PDF p.19
Manufacturer document
Viking Range, LLC (official manual PDF)
form F21216 EN (060113) / PDF p.18
Sources: the Viking 451 Series (p. 19) and 324 Series (p. 18) built-in dishwasher manuals; both print the same flash chart.
No. The reset is holding START for 4 seconds, and the chart lists no other owner step for this pair. If 1-1 flashes again after the reset, book a visit.
The chart does not say. It prints the label Pan Flood Sensor Disconnect without a location, so we cannot point you to it; a repeat after the reset needs a technician.
The chart does not rate it. The label speaks of a disconnect, not of water, but leave the dishwasher unused if water appears on the floor.
Book a visit if the pair repeats after the 4-second START reset and a short cycle. The chart gives no owner checks beyond that.
Viking codes, symptoms, parts, visits
1-2 means the POTS/PANS light flashes once and the NORMAL WASH light flashes twice. Viking's chart calls it Motor Control Status Error and prints only a reset.
A Viking dishwasher that leaves dishes dirty or cloudy is, per Viking's chart, mostly a loading, detergent or filter matter. Check the filters and strainer first, then the wash arms, rinse agent and detergent amount. Odor and slow drying have their own entries, covered below.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.