What it means
1-3 means the POTS/PANS light flashes once and the NORMAL WASH light flashes three times. Viking's chart calls it Motor Control Comms Error and prints only a reset.
Viking dishwasher 1-3 / Flash pairs
1-3 means the POTS/PANS light flashes once and the NORMAL WASH light flashes three times. Viking's chart calls it Motor Control Comms Error and prints only a reset.
Also shown as 1-3
1-3 means the POTS/PANS light flashes once and the NORMAL WASH light flashes three times. Viking's chart calls it Motor Control Comms Error and prints only a reset.
One, then three.
1-3 flashes again after the reset.
Your Viking checklist, kept on this device only

One, then three.

Hold START for 4 seconds.

Check the pair.

A comms error needs a technician if it repeats.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visit
A simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.
Motor Control Comms Error, with a single action: reset the unit and try again, then contact service if the problem persists.
Read the supporting manual1-2 is the status error of the same motor control. 3-1 is UI-MC Comm Error, the other communication row. The chart separates the three only by label.
Read the supporting manualTwo nearby notes are not about 1-3. The manual says Start/Resume blinks when a cycle is interrupted, and that the dishwasher stops if the door is opened mid-cycle. Neither is tied to this code.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20879C EN (022213) / PDF p.19
Manufacturer document
Viking Range, LLC (official manual PDF)
form F21216 EN (060113) / PDF p.18
Sources: the Viking 451 Series (p. 19) and 324 Series (p. 18) built-in dishwasher manuals; both print the same flash chart.
The chart does not say what the communication problem is. A loose cable inside the dishwasher is not an owner job in either manual, so that guess does not change your next step.
You cannot tell from the chart. Count the flashes: POTS/PANS once and NORMAL WASH three times is 1-3, while three and then one is 3-1.
Note the date and the cycle you ran. A code that returns after a reset is the case where the chart sends you to service, and those notes help the visit.
The manual says only that the dishwasher stops when the door is opened mid-cycle. It does not connect that to 1-3, so a code after a door-open is not explained by it.
Viking codes, symptoms, parts, visits
1-1 means the POTS/PANS light flashes once and the NORMAL WASH light flashes once. Viking's chart calls it Pan Flood Sensor Disconnect and prints only a reset: hold START for 4 seconds.
A Viking dishwasher that leaves dishes dirty or cloudy is, per Viking's chart, mostly a loading, detergent or filter matter. Check the filters and strainer first, then the wash arms, rinse agent and detergent amount. Odor and slow drying have their own entries, covered below.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.