Maintenance

The Time to Clean light on a Viking ice machine

On Viking 5 Series clear and nugget ice machines the Time to Clean light comes on after 6 months of use and stays on until you run the scale-removal clean; it is a reminder, not a breakdown. Empty the bin, add scale remover as the manual directs, run the cycle, flush the bin with hot water, sanitize it and restart. The FNIU515D flickers its lamps and uses only Viking Ice Machine Cleaner. [1][2][3]

An undercounter ice machine stands open and empty with a bowl of water and a cloth on the counter above.
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work
On this page
Key points
  • Time to Clean comes on after 6 months of use and stays on until the ice making system is cleaned. 12
  • The FNIU515D flickers its ice, no water and drain lamps in turn after 6 months of ice making. 3
  • The clear machine uses 8 ounces of Ice Machine Scale Remover; the FNIU515D uses 2 ounces of Viking Ice Machine Cleaner in two quarts. 13
  • Clean at least once a year, preferably twice, and more often in some water conditions. 12
  • Scale shows up as ragged, mis-shaped cubes, where normal cubes are tapered cylinders. 1

When does the Time to Clean light come on?#

On the 5 Series clear and nugget machines the Time to Clean light switches on after 6 months of use. It remains on until the ice making system is cleaned with the scale-removal process. The FNIU515D gives a different signal after a cumulative 6 months of ice making. 123

The troubleshooting guide for the clear and the nugget machines has one entry for it: the Time to Clean light is on, and the correction is to clean the ice making system. 12 So the light is upkeep, not an alarm, and there is nothing to repair when it appears. What matters is that the light does not go out by itself.

MachineThe signalThe cleaner
Clear ice FGIM5151 / FPIM5151Time to Clean light on after 6 months 1Ice Machine Scale Remover 1
Nugget FGNI515 / FPNI515Time to Clean light on after 6 months 2Scale remover solution 2
Nugget FNIU515DIce, no water and drain lamps flicker twice in sequence 3Viking Ice Machine Cleaner only 3

How often should an ice machine be cleaned at all?#

At least once a year, and preferably twice. The manuals add that some water conditions call for more frequent cleaning of the ice making section, and some carpets or pets for more frequent cleaning of the condenser. 12

The reason is mineral scale. The clear machine's manual explains that purer water freezes first, so dissolved minerals concentrate in the reservoir and can form hard deposits. Between 2 and 4 pints of water flow in per cycle, and 1 to 3.5 pints rinse the reservoir down the drain, which dilutes but does not remove all of it. 1 Built-up scale can shorten the machine's life, and ragged mis-shaped cubes are the visible sign; normal cubes are tapered cylinders. 1

How do I clear the light on a clear ice machine?#

Empty the bin, switch the machine to its clean mode, add 8 ounces of Ice Machine Scale Remover to the reservoir, run the machine for about half an hour, then let it flush for another half hour and finish with hot water. 1

  1. 1

    Scoop out the ice#

    Discard it or keep it in a chest or cooler. 1

    A hand tips a metal scoop of clear ice cubes from an open undercounter ice machine into a cooler beside it.
  2. 2

    Switch the machine off#

    Press and hold the On/Off button for 3 seconds until the blue light goes out. 1

  3. 3

    Start the clean mode#

    Hold Clean-Reset and On/Off down at once for 5 seconds; the Time to Clean light then blinks. 1

    A row of four small indicator lights on a stainless ice machine front, one lit green and the others dark.
  4. 4

    Pour in the scale remover#

    Add 8 ounces of Ice Machine Scale Remover to the reservoir. 1

    A gloved hand pours clear liquid from a glass pitcher into the water reservoir of an open undercounter ice machine.
  5. 5

    Run for about half an hour#

    Let the machine operate. 1

  6. 6

    Start the flush#

    Push and release On/Off. The light stays on steady and the machine flushes the solution out. 1

  7. 7

    Run another half hour, then stop#

    Push and release On/Off to end the cleaning process. 1

  8. 8

    Flush the bin and scrub the liner#

    Pour a gallon of hot water (95 to 115°F) into the bin, scrub the liner with scale remover mixed with hot water, rinse with hot water. 1

    A hand with a cloth wipes the empty white bin liner of an undercounter ice machine, a bowl of water on the floor.
  9. 9

    Sanitize, refill and restart#

    Sanitize the bin interior, put back the ice you removed, and push On/Off to restart ice making. 1

Wash the ice scoop regularly, like any food container. 1 The sanitizing mix is 1 ounce of household bleach in two gallons of hot water, wiped over the bin with a clean cloth, with a little poured down the drain, then left to air dry. 1

What is different on a nugget machine?#

The nugget FGNI515 clean is a longer, hands-on job. You open the bin, take out the back panel and the reservoir cover, move the float valve lever, drain the reservoir and then keep adding diluted scale remover as ice is made, for about 40 minutes. 2

The manual lists the key details. Mix 1.25 ounces of cleaner with 16 ounces of warm water, fill the reservoir with about 8 ounces, then hold Clean-Reset and On/Off for 5 seconds so the Time to Clean light blinks. The auger motor runs alone for 10 minutes, the compressor then starts, and ice making resumes in about 5 to 8 minutes. 2 Keep adding solution to hold the reservoir about half full, and when all 16 ounces are used, move the float lever back to ON. 2

After 40 minutes the machine and its lights switch off. You then drain the system, refit the cover and panel, flush a gallon of hot water through, scrub the liner, sanitize and press On/Off. 2 The manual warns that scale remover contains acids, which can burn skin, and says to wipe a spill at once with baking soda and water. It recommends rubber gloves and a squirt bottle. 2

How does the FNIU515D clean work?#

It uses a self-cleaning cycle with its own cleaner. After 6 months of ice making the ice, no water and drain lamps flicker twice in sequence, and keep doing so until the machine's cleaning function has been run. 3

The manual says to use only Viking Ice Machine Cleaner, and states that any other cleaner can damage the machine and void the warranty. 3 The sequence on page 15 is: dilute 2 ounces of cleaner into two quarts of water; set the lower front mode switch for cleaning; after 30 seconds add about a quart of the solution into the ice spout (a squeeze bottle helps); let it clean, drain and refill for about 10 minutes; wipe the reservoir with the remaining solution; rinse with clean water after 10 minutes; toggle the mode switch again; the cycle ends after about 10 more minutes and the lamps stop flickering. 3

The lamps keep signaling until the cleaning function has run. 13

What about the condenser and the bin?#

Vacuum the condenser when airflow is poor. On the clear and nugget machines, remove the kick plate and front service panel, vacuum the surface and do not dent the fins. On the FNIU515D, unplug first and use no cleaner on it. 123

The FNIU515D manual asks for condenser cleaning 2 to 3 times a year, using a vacuum, a soft brush or compressed air after removing the lower panel and the kick plate or grille. 3 The 5 Series troubleshooting tables list a dirty condenser under low capacity: check for a restricted drain or standing water in the bin, and clean the air-cooled condenser fins. 12 Never keep anything but ice in the bin, because labels from bottles can slip off and block the drain. 12 Our condenser entry describes the part.

A narrow vacuum nozzle is held against the dusty finned condenser behind the removed kick plate of an ice machine.
Vacuum the fins without denting them. 12

What if the light stays on, or no ice comes?#

If the light stays on after a full clean, run the sequence again and check the model's steps. If there is no ice, the guide lists the On/Off switch, the electrical breaker and a blue flashing Check Water light, which means the water supply is out. 12

The control checks for water every 20 minutes, and the machine restarts ice making by itself once water returns. 12 The FNIU515D prints Er codes in its lamp table: Er15 when no water is sensed for 2 minutes and Er16 when the lower limit is not sensed within 2 minutes of the drain valve operating. 3 Our entry for Time to Clean and the one for Check Water cover the 5 Series messages.

What helps a technician when the light keeps returning?#

Say the model, when you last ran a clean, which cleaner you used, what the lights show, whether the cubes are ragged, and whether the drain or the bin holds water.

  • Does Time to Clean return soon after a full clean?
  • Are the cubes ragged or capacity low?
  • Is Check Water flashing blue?
  • Was the condenser vacuumed recently?

The machines we work on are named on our ice maker service page.

Sources#

  1. Use & Care / 15"W. Undercounter/Freestanding Ice Machine / FGIM5151 FPIM5151Viking Range, LLC (official manual PDF) · printed code 070777-000 · PDF p.3 (safety), p.4 (Time to Clean, cleaning frequency), p.5 (maintenance), p.6 (condenser), p.7 (removing scale), p.8 (troubleshooting)
  2. Use & Care / 5 SERIES / 15"W. Undercounter/Freestanding Nugget Ice MachineViking Range, LLC (official manual PDF) · form F21311A EN (040116) · PDF p.4 (Time to Clean), p.6-9 (condenser, scale removal), p.10 (troubleshooting)
  3. Install / Use & Care MANUAL / Undercounter Nugget Ice Machine / FNIU515DViking Range, LLC (official manual PDF) · Rev C, printed code (051525) · PDF p.11 (cleaning signal), p.15 (cleaning), p.16 (condenser), p.17 (troubleshooting lamps)

Here to help

Good questions.
Clear answers.

Talk to our team
When does the Time to Clean light come on?

On the 5 Series clear and nugget machines it comes on after 6 months of use and stays on until the ice making system is cleaned. The FNIU515D signals after a cumulative 6 months of ice making with a flicker pattern. [1][2][3]

Is the light a breakdown warning?

No. The troubleshooting guide lists Time to Clean with one correction: clean the ice making system. It is a maintenance reminder, not an alarm. [1][2]

What cleaner does each machine take?

The clear and nugget 5 Series manuals name Ice Machine Scale Remover. The FNIU515D manual says to use only Viking Ice Machine Cleaner and warns that any other cleaner can cause damage and void the warranty. [1][2][3]

How long does the clean take?

The clear machine runs about half an hour plus another half hour of flushing. The nugget machine shuts off after about 40 minutes of adding solution. The FNIU515D cycle takes about 10 minutes per stage. [1][2][3]

How often should the condenser be cleaned?

The FNIU515D manual says 2 to 3 times a year, unplugged and without any cleaner on the condenser. The 5 Series manuals say to vacuum it, and not to dent the fins, when cubes or capacity drop. [1][2][3]

Let’s take care of it.

The burner will not light.
Let us take a look.