Using your appliance

Preparing a Viking oven for its self-clean cycle

Before a self-clean cycle on a Viking oven, take out the racks and every utensil, skip foil and liners, wipe large spills, and hand-wash the door up to the gasket, the frame and 2 inches inside the frame. Then close the door fully, set the selector to self-clean and turn the temperature knob to its stop. Plan 2-1/2 to 3-1/2 hours plus 30 minutes of cooldown. [1][2][3]

A hand wipes the frame of an open wall oven with a damp cloth, two racks leaning on the counter beside it.
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work
On this page
Key points
  • Remove racks and utensils; rack supports in the 5 and 7 Series ovens are made to stay. 123
  • No foil or liners, and never an oven cleaner inside the oven or on the raised door portions. 123
  • Wash the door by hand out to the gasket, plus the frame and 2 inches inside it. 123
  • Cycle length is about 2-1/2 hours (3 Series gas range) or 3-1/2 hours, plus 30 minutes of cooldown. 123
  • To stop a cycle, turn both knobs to OFF; the latch lets go when the cavity is safe. 123

What do I need to do before starting a Viking self-clean?#

Three things: take out the racks and every other item, wipe off large spills without any oven cleaner, and wash the door edge by hand. The three manuals we read print the same preparation list for the 3 Series range, the 5 and 7 Series electric ovens and the 7 Series range. 123

A pyrolytic cycle turns baked-on soil into ash. According to the manuals the oven climbs to elevated temperatures, an integral smoke eliminator helps cut odors, and a powder ash residue is left on the oven floor. 123 The preparation steps protect the oven and your racks from that heat, and they remove the soil the cycle cannot reach.

  1. 1

    Take out the racks, utensils and everything else#

    The high heat can discolor, warp and damage racks and utensils. 123

    An empty open oven cavity with bare walls, a round perforated fan cover on the back and an interior light glowing.
  2. 2

    Skip foil and liners#

    During the cycle, foil can burn or melt and damage the oven surface. 123

  3. 3

    Wipe large spills from the floor and sides#

    Oven cleaners are never used in a self-cleaning oven, nor on the raised parts of the door. 123

  4. 4

    Wash the door area by hand#

    Use detergent and hot water on the door as far as the gasket, on the frame, and on the first 2 inches inside it. Rinse well and dry. 123

  5. 5

    Vent the kitchen#

    Keep the kitchen well vented during the cycle. 123

Why do the racks come out?#

The manuals say the heat of the cycle can discolor, warp and damage them. The 5 and 7 Series manual adds a direct instruction in capitals not to clean the racks with the self-clean cycle, and says the rack supports are designed to remain in the oven during the cycle. 123

Wash the racks by hand instead, with detergent and hot water. The manuals say stubborn spots can be scoured with a soap-filled steel wool pad. 12 For a serious home cook with heavy roasting pans, this is the step that saves the racks from permanent damage.

Which parts of the oven need hand cleaning first?#

The door gasket area and the frame. The manuals say some areas are outside the cycle's reach, soil there bakes on and becomes very difficult to remove, and so you wash the door up to the gasket, the frame and 2 inches inside the frame first. 123

Keep ammonia, steel wool pads, abrasive cleansers and oven cleaners away from the cavity. The manuals list these as things that can permanently damage the finishes. 123

For large spills, wipe the oven floor and sides first, as the manuals direct.

How long does the cycle take?#

About 2-1/2 hours on the 3 Series gas range and about 3-1/2 hours on the 5 and 7 Series electric ovens and the 7 Series range. Each manual adds 30 minutes for the oven to cool enough for the door latch to disengage. The fan keeps running for the full cycle. 123

Model familyPrinted cycleCooldownFan
3 Series 30 in gas rangeAbout 2-1/2 hoursAbout 30 minutes moreRuns for the 2-1/2 hours 1
5 and 7 Series electric ovensAbout 3-1/2 hoursAbout 30 minutes moreRuns for the 3-1/2 hours 2
7 Series range (VDR)About 3-1/2 hoursAbout 30 minutes moreRuns for the 3-1/2 hours 3

The fan noise is expected. Our oven fan noise page explains why. On the 5 and 7 Series electric manual, self-clean is available on all ovens except the French door single or upper oven, which has Steam Clean for light cleaning instead. 2

How do I begin the cycle, and what does the latch do?#

Close the door fully, turn the selector clockwise to Self Clean, and turn the temperature knob to the clean setting stop. The clean light comes on, and within 30 seconds the automatic door latch engages. The latch holds the door shut for as long as the cavity is that hot. 123

The oven indicator light glows until the cavity reaches self-clean temperature, then it cycles on and off. On the 3 Series range, a door lock indicator light also comes on once the oven is hot enough. 12 The door cannot be opened until the oven cools to a safe temperature, and no amount of pulling helps.

Why will the oven not start the cycle?#

The manuals list two common causes. The door is not shut tight enough for the automatic latch to lock, or the temperature knob was not rotated past the clean mark until it hit its stop, which leaves the oven dirty afterward. 23

In a double oven only one cavity can self-clean at once. If you start the second while the first is cleaning, the manual says only the selector indicator lights, the temperature indicator does not, and the knob backlights come on without pulsing. 3

How do I stop a cycle early?#

Turn both the temperature knob and the oven function selector to OFF. Once the temperature has fallen to a safe level the latch lets go and you can open the door. Let everything cool fully, then clear the ash with a damp sponge or cloth. 123

If you cancel on a 7 Series range during the first 30 seconds, before the latch has fully engaged, the door may stay locked. The manual gives a knob sequence that makes the bezel pulse yellow, ending with both knobs off, and the lock releases when the solid yellow disappears. 3 Our oven door that stays shut page has the details.

What happens after the cycle?#

When the cycle is complete, turn the selector and temperature knob to OFF. After the cavity is fully cool, open the door, clear the ash from the surfaces with a damp cloth, and slide the racks back in. 123

The ash is a fine powder left in the bottom of the oven. If you see some soil left, check that the temperature knob was rotated past the clean mark until it hit its stop; the troubleshooting table names that as a reason soil remains. 23

Odor and smoke in the first few cycles are described as normal, from curing the binder in the insulation, and they fade. 123 Our self-clean problems page and the oven door latch entry cover other issues.

Our range repair page lists the oven jobs we take on.

What do I record about the cycle?#

Write down your model, how long you ran the cycle, what the door and lights did, and what you saw.

  • Which oven (upper or lower) and which model?
  • Did the clean light come on and the latch engage within 30 seconds?
  • Was the door still locked after the oven felt cool?
  • Did you remove the racks and use no foil or liners?

Sources#

  1. 3 Series Freestanding 30 in Gas Self-Clean Sealed Burner Range Use & CareViking Range, LLC (official manual PDF) · form F21184B EN (070115) · PDF p.19-21 (Cleaning and Maintenance, Self-Clean Cycle)
  2. Use & Care, Professional Built-In Electric Single and Double Ovens VSOE130 / VSOE527 / VSOE530Viking Range, LLC (official manual PDF) · form 066749-000 (082625) · PDF p.12, 27-29 (Self-Clean, Cleaning & Maintenance, troubleshooting)
  3. Use & Care / Professional Freestanding Ranges / Built-In RangetopsViking Range, LLC (official manual PDF) · form 066424-000 (103122) · PDF p.11, 29, 31, 33 (self-clean lighting, cleaning, cycle, troubleshooting)

Here to help

Good questions.
Clear answers.

Talk to our team
Do the racks stay in during a Viking self-clean?

No. All three manuals say to remove the oven racks and other items first, because the heat can discolor, warp and damage them. The 5 and 7 Series manuals add that the rack supports are made to stay in. [1][2][3]

Can I line the oven with foil to catch drips?

No. Foil and liners are ruled out in all three manuals, since foil can burn or melt during the cycle and mark the oven surface. [1][2][3]

How long is a self-clean cycle?

About 2-1/2 hours on the 3 Series gas range and about 3-1/2 hours on the 5 and 7 Series ovens, each followed by 30 more minutes before the latch lets go. [1][2][3]

Is smoke or odor during the first cycles normal?

Some odor and smoking is expected the first few times, from curing the binder in the high-density insulation. The manuals say it disappears once the insulation is cured, and to keep the kitchen well vented. [1][2][3]

Why will the oven not start self-clean?

The manual's first cause is a door that is not shut tight enough for the automatic latch to lock. In a double oven only one cavity can self-clean at once. [2][3]

Let’s take care of it.

The burner will not light.
Let us take a look.