Viking ice maker ICE lamp blinking (2 seconds on, 1 off) / Mode, not a failure

Viking ice-maker
error ICE lamp blinking (2 seconds on, 1 off)

Ice-maker / display referenceICE lamp blinking (2 seconds on, 1 off)

A slow ICE lamp, on for 2 seconds and off for 1, means the storage bin on a Viking FNIU515D nugget machine has filled up. Nothing is wrong. The lamp goes out once the sensor sees the release temperature, and ice making resumes.

Also shown as ICE lamp blinking (2 seconds on, 1 off)

Last reviewed

Ice-maker / display referenceICE lamp blinking (2 seconds on, 1 off)
Meaning
A slow ICE lamp, on for 2 seconds and off for 1, means the storage bin on a Viking FNIU515D nugget machine has filled up. Nothing is wrong. The lamp goes out once the sensor sees the release temperature, and ice making resumes.
Who handles it
Normal
Related codes
Source
Install / Use & Care MANUAL / Undercounter Nugget Ice Machine / FNIU515D

What Viking ice maker ICE lamp blinking (2 seconds on, 1 off) means.

What it means

A slow ICE lamp, on for 2 seconds and off for 1, means the storage bin on a Viking FNIU515D nugget machine has filled up. Nothing is wrong. The lamp goes out once the sensor sees the release temperature, and ice making resumes.

What you can safely check

Lit two seconds and dark one is the full-bin signal.

When to call a technician

You can see an empty bin yet the slow blink carries on.

Your Viking checklist, kept on this device only

Safe checks, in order.

0 of 4 checks done
  1. Viking ice maker ICE lamp blinking (2 seconds on, 1 off): Ice makers in a thoughtfully designed home
    Illustration. Follow your model’s instructions.
    Before you begin

    Time the blink

    Lit two seconds and dark one is the full-bin signal. A faster blink, once per second, belongs to the washing mode.

  2. Heavy metal control knobs on a professional-style range
    Illustration. Follow your model’s instructions.
    Check 2

    Scoop some ice

    Take some ice out and give the bin time to warm that sensor. Once it reads the release temperature, the lamp goes out by itself.

  3. A technician holds a tablet showing a blank checklist beside a stainless gas range with a skillet on a lit burner.
    Illustration. Follow your model’s instructions.
    Check 3

    Check the mode switch

    If a wash run was started by accident, the lamp blinks every second until the control is set to off. Return it to ice afterwards.

  4. A technician testing a range burner with a meter
    Illustration. Follow your model’s instructions.
    Check 4

    Book only if the lamp lies

    An empty bin with the slow blink still going suggests the bin sensor is misreading, and that detail helps the booking.

Still showing ICE lamp blinking (2 seconds on, 1 off)?

Pass along the model and the checks you ran, then open a visit request from this spot.

Book a visit

Ice maker cycle.

Conceptual Ice maker sectionWater inletEvaporator plateIce bin and bin sensorDrain pumpControl12345
  1. 1Water inlet
  2. 2Evaporator plate
  3. 3Ice bin and bin sensor
  4. 5Control

A simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.

A little more context.

What is the slow ICE blink telling me?

The bin is full. The lamp stays on for 2 seconds, drops out for 1 and repeats.

Read the supporting manual

When does the lamp go off?

The chart says it turns off when the ice full sensor detects the release temperature. In practice, that means the bin has some room again.

Read the supporting manual

Is a quick ICE blink the same thing?

No. Put the control in the wash position and the ICE lamp blinks every second; draining stops once you set it back to off.

Read the supporting manual

What would make me worry about the slow blink?

Only an obviously empty bin. The lamp then disagrees with what you can see, which puts the bin sensor under suspicion.

Read the supporting manual

The manual behind the message.

Manufacturer document

Install / Use & Care MANUAL / Undercounter Nugget Ice Machine / FNIU515D

Viking Range, LLC (official manual PDF)

Rev C, printed code (051525) / PDF p.17

Lamp chart, page 17 of the FNIU515D guide. The older clear-ice machines do not print this pattern.

Here to help

Good questions.
Clear answers.

Talk to our team
Does a blinking ICE lamp mean the machine is stuck?

No. A slow blink over a full bin says it is finished for now, and it resumes when the sensor sees a lower temperature.

How soon does ice making resume?

No time is printed. It depends on how quickly removed ice lets the bin sensor warm to the release temperature.

Two blink speeds exist. Which is which?

Slow, 2 seconds on and 1 off, is a full bin. One blink a second is the wash mode, and the control position tells you which you started.

Can I leave the lamp blinking overnight?

Yes, if the bin is full. Nothing is wrong, and the machine simply idles until you take ice out.

Let’s take care of it.

The burner will not light.
Let us take a look.