Read the whole display
Give the exact message and the model, since the RVM320 shows CHILD LOCK ON where others show LOCK ON.
Model-specific code library
Five messages are decoded across Viking microwave and drawer microwave manuals: ERROR, ERROR 2 HOUR MAX TIME TOUCH CLEAR, LOCK ON, WELCOME and DEMO ON. The ERROR messages mean a bad entry or a stopped sensor program.
DEMO ON means a Viking microwave is in showroom demonstration mode: the controls answer, yet nothing heats. Cancel it with your model’s key sequence, or unplug the oven and plug it back in.
Read the DEMO ON checks5 researched microwave codes. What a message means shifts from one Viking series to the next, so your own manual settles it.
DEMO ON means a Viking microwave is in showroom demonstration mode: the controls answer, yet nothing heats. Cancel it with your model’s key sequence, or unplug the oven and plug it back in.
Normal, but it will not heatERROR on a Viking microwave means the oven refused an entry or stopped a sensor program. A bad clock time, an out-of-range weight, or a sensor cycle that never detected steam all show it. Touch Stop/Clear and start the step again.
Check, then bookOn a Viking VMODC5240 convection drawer oven this message means the time you keyed is over that program’s ceiling: 2 hours for bake and roast, 4 for warm and proof, 30 minutes for grill. Touch Clear and key a shorter time.
NormalLOCK ON means the Control Lock is switched on and the keypad is ignoring touches. It blocks accidental starts, and on a drawer oven it also stops the drawer from moving. A three-second hold on the lock key releases it.
NormalWELCOME shows on a Viking microwave when it is first plugged in, and again when power returns after an interruption. Clear the screen with Stop/Clear, then set the clock again. Any program that was running is erased.
Normal
Five messages are decoded across Viking microwave and drawer microwave manuals: ERROR, ERROR 2 HOUR MAX TIME TOUCH CLEAR, LOCK ON, WELCOME and DEMO ON. The ERROR messages mean a bad entry or a stopped sensor program.
Read in the RVM320, VMOD5240, VMODC5240 and VMDD5306 manuals. Key sequences differ between them.
Give the exact message and the model, since the RVM320 shows CHILD LOCK ON where others show LOCK ON.
Unplug the microwave before you clean around the door seal. Leave the cabinet closed.
A Viking microwave that runs but does not warm food is first checked for demo mode, wrong controls and lost power, then with a one-cup water test. If the light, fan and turntable work and the water stays cold after a minute at full power, the heating itself needs a technician.
On a Viking DrawerMicro or built-in microwave, controls that do nothing are often the control lock, a power interruption or demo mode. Hold the lock pad for 3 seconds, restore power and the clock, and cancel demo mode. Book a technician if the pads stay dead.
Rely on the guide for your precise series, and read how we research these pages.
Read in the RVM320, VMOD5240, VMODC5240 and VMDD5306 manuals. Key sequences differ between them.
Snap the whole microwave display and the data plate. Note what the appliance was doing the moment the message came up, and do not borrow an explanation meant for some other product.
A phrase people once searched for is no substitute for the maker's own wording. When our microwave documents leave a message undecoded, it stays listed by name and we point you to help without naming any part or cause.
Open a manufacturer document from this microwave library and match the model on its cover to the plate on your appliance. A different series comes with its own guide.