What it means
ERROR on a Viking microwave means the oven refused an entry or stopped a sensor program. A bad clock time, an out-of-range weight, or a sensor cycle that never detected steam all show it. Touch Stop/Clear and start the step again.
Viking microwave ERROR / Sensors and temperature
ERROR on a Viking microwave means the oven refused an entry or stopped a sensor program. A bad clock time, an out-of-range weight, or a sensor cycle that never detected steam all show it. Touch Stop/Clear and start the step again.
Also shown as ERROR
ERROR on a Viking microwave means the oven refused an entry or stopped a sensor program. A bad clock time, an out-of-range weight, or a sensor cycle that never detected steam all show it. Touch Stop/Clear and start the step again.
It wipes the entry and the message.
ERROR appears on every sensor program even with a simple, dry dish.
Your Viking checklist, kept on this device only

It wipes the entry and the message. Every cause the manuals list starts with that pad.

The clock runs on 12 hours. An incorrect time brings up ERROR, so key the digits again in order and confirm with Timer/Clock.

If ERROR came during Sensor Cook or Reheat, the oven did not detect steam and switched off. Use manual time and power, and check the food temperature.
Some foods work best covered, and the guide names the cover for each sensor program. Follow it, then try the sensor program once more.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visitA simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.
Three things in the manuals: a clock time that cannot exist, a weight outside the allowed range, and a sensor program that never sees vapor.
Read the supporting manualOn most foods ERROR shows and the oven shuts off. Popcorn behaves differently: the oven stops and returns to the time of day.
Read the supporting manualThe 3 Series guide’s answer: touch Stop/Clear, finish by manual time and power, and test the food temperature before adding minutes.
Read the supporting manualYes, on programs that ask for a weight. Typing more or less than the chart allows brings up ERROR, so check the range for that program.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
F20972A (061715) / PDF p.13, p.17, p.21
Manufacturer document
Viking Range, LLC (official manual PDF)
060036-000 / PDF p.16
Read in the RVM320 3 Series and VMOD5240 manuals; the VMOC506 and VMDD5306 guides print it too. The ERROR 2 HOUR MAX message on the convection drawer is a separate page.
Usually not. The manuals tie it to entries the oven cannot accept or a sensor cycle that failed to see steam, both of which clear with Stop/Clear.
The clock accepts only a valid 12-hour time. Anything else is refused with ERROR, so touch Stop/Clear and key it in again.
The sensor works from steam leaving the food. The guide lists a cover for each program, with about half an inch left open for steam.
On the 3 Series the oven switches off and the time of day returns, rather than showing ERROR. Other foods show ERROR.
Viking codes, symptoms, parts, visits
On a Viking VMODC5240 convection drawer oven this message means the time you keyed is over that program’s ceiling: 2 hours for bake and roast, 4 for warm and proof, 30 minutes for grill. Touch Clear and key a shorter time.
A Viking microwave that runs but does not warm food is first checked for demo mode, wrong controls and lost power, then with a one-cup water test. If the light, fan and turntable work and the water stays cold after a minute at full power, the heating itself needs a technician.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.