What it means
On a Viking 5 Series gas side burner, an igniter that stays dark when you push in the knob points at the electrical supply, such as a tripped GFI outlet or a loose plug. Switch the gas off, reset the GFI and call us if it stays dark.
Viking grill Igniter does not glow / Ignition and gas
On a Viking 5 Series gas side burner, an igniter that stays dark when you push in the knob points at the electrical supply, such as a tripped GFI outlet or a loose plug. Switch the gas off, reset the GFI and call us if it stays dark.
Also shown as Igniter does not glow
On a Viking 5 Series gas side burner, an igniter that stays dark when you push in the knob points at the electrical supply, such as a tripped GFI outlet or a loose plug. Switch the gas off, reset the GFI and call us if it stays dark.
If you smell gas, shut every control off and leave the burner unlit.
The igniter is still dark after the GFI has been reset.
Your Viking checklist, kept on this device only

Every control knob should sit at OFF. If you already tried to light the burner, give accumulated gas 5 minutes to clear.

The accessory runs from a 120 V GFI outlet or the grill’s own transformer. The guide names a tripped GFI as one reason the electrics are dead.

A connector can shake loose in transit. The accessory’s harness plugs into the grill’s 4-pin connector or into an optional switch kit.
Push in and hold the knob 5 to 7 seconds so the igniter warms, then turn to LITE. A healthy igniter glows bright and steady.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visit
A simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.
Bright and steady while the gas control knob is pushed in. That is the check the guide uses after installation.
Read the supporting manualPower. A connection may have loosened in shipping, or the GFI outlet may have tripped and want a reset.
Read the supporting manualSomewhat. You hold the knob 5 to 7 seconds so the igniter can heat, then turn to LITE.
Read the supporting manualAfter a failed igniter attempt and a 5 minute wait, with no gas smell, and with your face kept well back.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
no edition code in the cached text / PDF p.13, p.14, p.17
The VQGSB5131 double side burner and the VQGPB5201 power burner, both outdoor-kitchen accessories that sit next to a Viking grill.
No. The igniter is electrical. A gas smell is its own warning: shut everything off first and sort out the leak.
The igniter needs a few seconds to heat before the burner will catch, so the guide asks for 5 to 7.
Per the lighting steps, knob off and a 5 minute wait if it has not lit within 4 seconds.
Near the accessory, fitted by an electrician, either inside the island or beside a freestanding unit.
Viking codes, symptoms, parts, visits
A whooshing sound from a Viking propane side burner in freezing weather means the flame may be burning inside the burner rather than above it. Turn the knob off straight away to put it out, then light the burner again.
A Viking 5 Series gas side or power burner lights with a hot surface igniter. Push the knob in and hold it 5 to 7 seconds before turning to LITE, and the igniter should glow bright and steady. If it does not, check the GFI outlet, the burner seating and the wind, then book a technician.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.