What it means
FU on a Viking Designer cooktop is a key error, the same name the manual gives FA, FC and FJ. All heating elements stop and FU shows on the timer display. No reset is listed.
Viking cooktop FU / Control code
FU on a Viking Designer cooktop is a key error, the same name the manual gives FA, FC and FJ. All heating elements stop and FU shows on the timer display. No reset is listed.
Also shown as FU
FU on a Viking Designer cooktop is a key error, the same name the manual gives FA, FC and FJ. All heating elements stop and FU shows on the timer display. No reset is listed.
Hold LOCK for 2 seconds.
FU appears on the timer display.
Your Viking checklist, kept on this device only

Hold LOCK for 2 seconds.

Dry the touch area.

Capital F and capital U.

A key error needs a technician.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visitA simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.

Component reference
Viking Designer electric cooktops run on touch controls.
Read the definitionA key error, the same name the manual gives FA, FC and FJ.
Read the supporting manualThe manual names them the same. FU is the last key error row in the table, after FL, and it is followed by Fd.
Read the supporting manualThe lock function locks all keys but the ON/OFF ones. The keys are automatically locked at start-up, and the control locks itself after one minute of non-use.
Read the supporting manualA cooktop that will not function may be in lockout mode, which you unlock. That is separate from FU.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20699 EN (091509J) / PDF pp.12–16
Source: the Viking Designer built-in electric cooktop use and care manual, Error Codes table on p. 16.
No. Lockout is a normal state with a lock indicator and the fix is to unlock.
Hold the LOCK key for two seconds. That unlocks a cooktop in lockout mode, which is a normal state and separate from FU.
Yes, the keys lock automatically at start-up, and the control locks itself after one minute of non-use. A locked keyboard is not the same as FU.
No. The manual lists no reset for FU, a key error. All heating elements stop and FU shows on the timer display, so a visit is the next step.
Viking codes, symptoms, parts, visits
FJ on a Viking Designer cooktop is a key error, named the same way as FA, FC and FU. All heating elements stop and FJ shows on the timer display. No reset is listed.
Viking’s guides split a dark burner by what the igniter does. Silence means the igniter has no electricity. Clicking without a flame means gas is not arriving. Work out which one you have, try the matching steps below, and call a technician when the burner never catches.
Viking Designer electric cooktops run on touch controls. A control panel that finds an electronics problem stops all heating elements and shows F plus a second letter on the timer display. The F20699 table lists 14 of them, from key and keyboard errors to temperature sensor and relay errors. On the 6 Series induction cooktops you must hold a touch for a few seconds.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.