What it means
Fr on a Viking Designer cooktop is a relay error. A relay switches power to the elements; the control stops all heating and shows Fr on the timer display. The manual lists no reset.
Viking cooktop Fr / Control code
Fr on a Viking Designer cooktop is a relay error. A relay switches power to the elements; the control stops all heating and shows Fr on the timer display. The manual lists no reset.
Also shown as Fr
Fr on a Viking Designer cooktop is a relay error. A relay switches power to the elements; the control stops all heating and shows Fr on the timer display. The manual lists no reset.
Capital F, lowercase r.
Fr appears on the timer display.
Your Viking checklist, kept on this device only

Capital F, lowercase r.

The elements are stopped on purpose.

General step; the manual lists none.

A relay is a technician matter.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visitA simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.

Component reference
Viking Designer electric cooktops run on touch controls.
Read the definitionThe control reports a problem with the switching of power. The manual does not detail it.
Read the supporting manualThe troubleshooting table says heating elements can cycle off even at the highest setting because their temperature limiters briefly shut them off, which it calls a normal condition during rapid heat-up. The element cycles back on by itself.
Read the supporting manualFH concerns memory. Fr concerns switching.
Read the supporting manualThe control stops the elements until it is cleared.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20699 EN (091509J) / PDF pp.12–16
Source: the Viking Designer built-in electric cooktop use and care manual, Error Codes table on p. 16.
No. Cycling off at the highest setting is the limiter at work and the element returns by itself. Fr shows on the timer display.
The HOT SURFACE indicators remain on until the zone cools below a safe temperature, about 150 F.
Yes, lowercase r, and it is a separate row from the key errors.
The manual lists no reset.
Viking codes, symptoms, parts, visits
FO on a Viking Designer cooktop is a software error. The control stops all heating elements and shows FO on the timer display. The manual lists no reset.
Viking’s guides split a dark burner by what the igniter does. Silence means the igniter has no electricity. Clicking without a flame means gas is not arriving. Work out which one you have, try the matching steps below, and call a technician when the burner never catches.
Viking Designer electric cooktops run on touch controls. A control panel that finds an electronics problem stops all heating elements and shows F plus a second letter on the timer display. The F20699 table lists 14 of them, from key and keyboard errors to temperature sensor and relay errors. On the 6 Series induction cooktops you must hold a touch for a few seconds.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.