What it means
FO on a Viking Designer cooktop is a software error. The control stops all heating elements and shows FO on the timer display. The manual lists no reset.
Viking cooktop FO / Control code
FO on a Viking Designer cooktop is a software error. The control stops all heating elements and shows FO on the timer display. The manual lists no reset.
Also shown as FO
FO on a Viking Designer cooktop is a software error. The control stops all heating elements and shows FO on the timer display. The manual lists no reset.
Capital F and capital O, not zero.
FO appears on the timer display.
Your Viking checklist, kept on this device only

Capital F and capital O, not zero.

This is our general step, since the manual lists none.

Give it a minute.

A software error needs a technician.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visitA simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.

Component reference
Viking Designer electric cooktops run on touch controls.
Read the definitionThe control's program reported a problem. The manual gives no more detail.
Read the supporting manualViking prints a letter O. Report it exactly as shown.
Read the supporting manualFH concerns the stored memory; FO concerns the software.
Read the supporting manualDirectly after FJ and before FL, listed as a single row.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20699 EN (091509J) / PDF pp.12–16
Source: the Viking Designer built-in electric cooktop use and care manual, Error Codes table on p. 16.
No. The manual lists no reset and gives no update procedure.
Yes. All the heating elements stop when the control declares an error.
Up to 10 hours continuously before the control stops activity.
The error letters show on the timer display.
Viking codes, symptoms, parts, visits
FH on a Viking Designer cooktop is a control error (EEPROM), which is the memory chip that keeps the control's settings. All elements stop and FH shows on the timer display.
Viking’s guides split a dark burner by what the igniter does. Silence means the igniter has no electricity. Clicking without a flame means gas is not arriving. Work out which one you have, try the matching steps below, and call a technician when the burner never catches.
Viking Designer electric cooktops run on touch controls. A control panel that finds an electronics problem stops all heating elements and shows F plus a second letter on the timer display. The F20699 table lists 14 of them, from key and keyboard errors to temperature sensor and relay errors. On the 6 Series induction cooktops you must hold a touch for a few seconds.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.