What it means
FH on a Viking Designer cooktop is a control error (EEPROM), which is the memory chip that keeps the control's settings. All elements stop and FH shows on the timer display.
Viking cooktop FH / Control code
FH on a Viking Designer cooktop is a control error (EEPROM), which is the memory chip that keeps the control's settings. All elements stop and FH shows on the timer display.
Also shown as FH
FH on a Viking Designer cooktop is a control error (EEPROM), which is the memory chip that keeps the control's settings. All elements stop and FH shows on the timer display.
Capital F and capital H.
FH appears on the timer display.
Your Viking checklist, kept on this device only

Capital F and capital H.

The control has stopped the elements.

The manual lists no reset; this is our general step.

A memory error is a control board matter.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visitA simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.

Component reference
Viking Designer electric cooktops run on touch controls.
Read the definitionA chip that stores settings in memory; the manual names it only in the label "Control error (EEPROM)".
Read the supporting manualFO is a software error and F5 is a communication error. FH concerns the stored memory of the control.
Read the supporting manualWhen the cooktop is connected to the power supply all lights and digits turn on to indicate a proper activation. This takes a few seconds and the control then turns off automatically.
Read the supporting manualThe manual does not suggest so. It lists FH among the electronic checks the control makes on itself.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20699 EN (091509J) / PDF pp.12–16
Source: the Viking Designer built-in electric cooktop use and care manual, Error Codes table on p. 16.
The manual does not list a reset for FH.
On the timer display, as F and a second letter.
Yes. The control stops all the heating elements when it declares an error.
It is printed in the Designer built-in electric cooktop manual, form F20699.
Viking codes, symptoms, parts, visits
F5 on a Viking Designer touch-control cooktop is listed as a communication error. The control has two boards, and the error detection system checks that they talk to each other. All heating elements stop and F5 shows on the timer display.
Viking’s guides split a dark burner by what the igniter does. Silence means the igniter has no electricity. Clicking without a flame means gas is not arriving. Work out which one you have, try the matching steps below, and call a technician when the burner never catches.
Viking Designer electric cooktops run on touch controls. A control panel that finds an electronics problem stops all heating elements and shows F plus a second letter on the timer display. The F20699 table lists 14 of them, from key and keyboard errors to temperature sensor and relay errors. On the 6 Series induction cooktops you must hold a touch for a few seconds.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.