What it means
FL on a Viking Designer cooktop is a keyboard error tied to ambient light. The control checks the light conditions around the keyboard. All elements stop and FL shows on the timer display.
Viking cooktop FL / Control code
FL on a Viking Designer cooktop is a keyboard error tied to ambient light. The control checks the light conditions around the keyboard. All elements stop and FL shows on the timer display.
Also shown as FL
FL on a Viking Designer cooktop is a keyboard error tied to ambient light. The control checks the light conditions around the keyboard. All elements stop and FL shows on the timer display.
Strong direct light on the glass may be involved, since the check concerns ambient light.
FL appears on the timer display.
Your Viking checklist, kept on this device only

Strong direct light on the glass may be involved, since the check concerns ambient light.

Block bright light and watch whether the code clears.

The elements are stopped.

If FL stays, a technician is needed.
Pass along the model and the checks you ran, then open a visit request from this spot.
Book a visitA simplified sketch, because the inside of a Viking differs by series. Tap a highlighted part for its photo and the matching test.

Component reference
Viking Designer electric cooktops run on touch controls.
Read the definitionThe detection system checks ambient light conditions as part of the keyboard function. FL is the keyboard error tied to that check.
Read the supporting manualThe label points that way, but the manual gives no cause or reset. The troubleshooting table notes that under direct or bright lighting you may see through the black glass or notice a red tint, which it calls normal.
Read the supporting manualBoth are keyboard errors. Fb is the plain one and FL carries the ambient light label.
Read the supporting manualThe error letters appear on the timer display, which also shows the 00 to 99 timer value.
Read the supporting manualManufacturer document
Viking Range, LLC (official manual PDF)
form F20699 EN (091509J) / PDF pp.12–16
Source: the Viking Designer built-in electric cooktop use and care manual, Error Codes table on p. 16.
No. The manual says a see-through or red look under bright light is a normal property of black ceramic glass.
On the timer display, as F and a second letter.
No. The control stops all the heating elements.
Fd tests the LEDs and FL concerns the keyboard's light sensing.
Viking codes, symptoms, parts, visits
Fb on a Viking Designer cooktop is listed as a keyboard error, a different row from the key errors FA, FC, FJ and FU. All heating elements stop and Fb shows on the timer display.
Viking’s guides split a dark burner by what the igniter does. Silence means the igniter has no electricity. Clicking without a flame means gas is not arriving. Work out which one you have, try the matching steps below, and call a technician when the burner never catches.
Viking Designer electric cooktops run on touch controls. A control panel that finds an electronics problem stops all heating elements and shows F plus a second letter on the timer display. The F20699 table lists 14 of them, from key and keyboard errors to temperature sensor and relay errors. On the 6 Series induction cooktops you must hold a touch for a few seconds.
Book a diagnostic for your series at the appliance itself.
Office particulars and the entry details to give us.